When will it stop, motor locked up
06-26-2013, 11:45 AM
#21
TECH Resident
Thread Starter
iTrader: (7)
Join Date: Dec 2008
Location: Greenville,SC
Posts: 817
Likes: 0
Received 0 Likes
on
0 Posts
Teflon doesn't give out that easily unless it's installed wrong or something else is amiss. If this isn't top end related you need to take the block to another shop and have them check out the block to see if it's true. If it did hydrolock then most likely you have a rod or two that is no longer straight.
06-26-2013, 12:16 PM
#22
Village Troll 
iTrader: (2)
I sort of feel your pain. My **** is on jackstands, only needs valvesprings replaced, hasn't been run for months, yet I can't find the motivation to take the couple of hours to get it done. I think if something like that would happen to my heap I would set it on fire.
