my waterpump weep hole mod
#23
TECH Veteran
Thread Starter
iTrader: (10)
Join Date: Jul 2006
Location: Rialto CA
Posts: 4,770
Likes: 0
Received 0 Likes
on
0 Posts
ok here are the pictures of the routing. it goes alllll the way to the rear of the K member by the deep side of the oil pan.
i zip tied it to the engine oil cooler hose down (look at the zip ties)
then i opened up the holder for the cooler hard line and tucked it in there beside it. note: it is pretty much as tight as a plug wire loom, so it wont vibrate out.
you can see pretty clear how its routed and is near the motor mount for reference.
and the final result:
i havent cut it down fully, i could take an inch or 2 off of the end so it doesnt hang as much, but who really looks down there anyways.
i zip tied it to the engine oil cooler hose down (look at the zip ties)
then i opened up the holder for the cooler hard line and tucked it in there beside it. note: it is pretty much as tight as a plug wire loom, so it wont vibrate out.
you can see pretty clear how its routed and is near the motor mount for reference.
and the final result:
i havent cut it down fully, i could take an inch or 2 off of the end so it doesnt hang as much, but who really looks down there anyways.