NiteRiderWS6

iTrader: (2)

well this noise actually just started, when i step in on the clutch there is a loud sound as if somthing is rubbing but when i let off it goes away what could this be? here are some videos

*watch in HD for best sound*

http://www.youtube.com/watch?v=_Ip-cgOvVyQ

outside the car, noise starts right when video starts

http://www.youtube.com/watch?v=T32ykk7M1DY

NiteRiderWS6

iTrader: (2)

no one??

NiteRiderWS6

iTrader: (2)

would really like some help with this

NiteRiderWS6

iTrader: (2)

well got the car home today and the noise got louder, i go to push the clutch in and it has no resistance, just goes all the way to the floor and back up, all the fluid was on the ground. and it was coming from the area shown in the pictures any idea what this was?

Chris05ssTruck

iTrader: (9)

U might have a leaky slave...that appers to be where the fluid is comming from.
Tranny will have to come out...
Check to be sure u have fluid in the resivor before u start it/drive it anymore.

SoxXpupPeT

iTrader: (34)

hmmm the slave might of gone. or you lost the front seal on your transmission. that noise could of been your front bearing. pull the tranny (invest in a tranny jack) and check everything. you will most likely also need a new clutch if any oil got on it

NiteRiderWS6

iTrader: (2)

i cant drive it, the clutch dosent work its just extremely loose and it wont go into gear

NiteRiderWS6

iTrader: (2)

and everyone is telling me its the slave cylinder and i have to replace the clutch to, could i use the Bell housing, clutch, pressure plate, and pilot bearing, flywheel out of an 08 LS3 Corvette??