vibrations at speed with poly trans mount
#41
TECH Enthusiast
Thread Starter
iTrader: (20)
Join Date: Sep 2005
Location: Carmel, NY
Posts: 741
Likes: 0
Received 0 Likes
on
0 Posts
what do you mean rotated the wrong way? That matters? lol....I think i am going to get an alignment so I could get my pinion angle corrected the right way because ive been trying and I cant seem to get it.
Arent SS's an inch lower from the factory than z28s? Thats what i thought i heard once.....would that affect the pinion angle if it was set to 0 for a z28 by UMI because it still vibrated when it was set by them after the install.
Arent SS's an inch lower from the factory than z28s? Thats what i thought i heard once.....would that affect the pinion angle if it was set to 0 for a z28 by UMI because it still vibrated when it was set by them after the install.
#43
TECH Enthusiast
Thread Starter
iTrader: (20)
Join Date: Sep 2005
Location: Carmel, NY
Posts: 741
Likes: 0
Received 0 Likes
on
0 Posts
I also have an update...i narrowed the vibration down from 70-86 mph by tweaking the pinion angle again...im pretty sure i left it at -1....I have to tweak it a little more hopefully that solves the problem.
#44
http://m.youtube.com/#/watch?v=bv-VM...%3Dbv-VMwTpREc
Is this similar to your vibration I've been chasing this one for about a year now built t56 moser 12 bolt spohn drive shaft. And I have a poly Trans mount
Is this similar to your vibration I've been chasing this one for about a year now built t56 moser 12 bolt spohn drive shaft. And I have a poly Trans mount