Cags Eliminator Connector
03-04-2005, 02:03 AM
#1
Launching!
Thread Starter
iTrader: (32)
Join Date: Feb 2002
Location: Detroit area
Posts: 215
Likes: 0
Received 0 Likes
on
0 Posts
Cags Eliminator Connector I have found the part number for the wire harness connector that plugs into the skip shift solenoid. It can be used to seal water and dirt from entering the solenoid.
I am wondering if anyone can find the mate to this connector so that we can build our own weatherproof eliminator using a 2.2K resistor.
The Harness end is: #12052646 2 Way Metri-Pack 150 Series (WH)
I believe this is considered the Male end. Can anyone come up with the part number for the Female end?
I am wondering if anyone can find the mate to this connector so that we can build our own weatherproof eliminator using a 2.2K resistor.
The Harness end is: #12052646 2 Way Metri-Pack 150 Series (WH)
I believe this is considered the Male end. Can anyone come up with the part number for the Female end?
Last edited by gto69judge; 03-04-2005 at 02:11 AM.
03-04-2005, 08:08 PM
#2
Launching!
Thread Starter
iTrader: (32)
Join Date: Feb 2002
Location: Detroit area
Posts: 215
Likes: 0
Received 0 Likes
on
0 Posts
Eliminator for only $16 shipped I decided to order an assembled eliminator since it was only $16 including shipping. ShouldaboughtheZ suggested it. See link below.
https://ls1tech.com/forums/wiring-stereo-electronics/285000-connector-plugs-into-cags-solenoid.html
https://ls1tech.com/forums/wiring-stereo-electronics/285000-connector-plugs-into-cags-solenoid.html
