LT1 pedal & crossmember in LS1 car?
#1
TECH Fanatic
Thread Starter
iTrader: (1)
Join Date: Dec 2004
Location: SW Iowa
Posts: 1,015
Likes: 0
Received 0 Likes
on
0 Posts
LT1 pedal & crossmember in LS1 car?
I am beginning a 6 spd swap in my Z next week, and I have all of the parts from a '97. I was wondering if I can use the pedal assembly and crossmember from the '97 on the '98. Can anybody help me out on this?
#5
TECH Fanatic
Thread Starter
iTrader: (1)
Join Date: Dec 2004
Location: SW Iowa
Posts: 1,015
Likes: 0
Received 0 Likes
on
0 Posts
Actually, it's the entire assembly, (all 3 pedals), from the '97. All of the switches are on it as well. I'm hoping it will work, as far as bolting in, using the switches, and hooking up the hydraulics. Can anybody verify this for me?
#7
12 Second Club
iTrader: (3)
Join Date: Sep 2003
Location: Lubbock, TX
Posts: 2,680
Likes: 0
Received 0 Likes
on
0 Posts
i just did a M6 swap in my car someone told me the pedals are the same from a different forum... but i would still check to be sure... could call the dealer and ask if the part numbers are different for the pedal assemblies... the crossmember i dont know about that at all could just check the part numbers again at the dealer if there the same.. same part, if different... different part