i was driving home from work, was in third gear, about to shift into fourth, pressed the clutch and heard a snap! all of a sudden the clutch didnt work, couldnt change gears and had to pull over onto the shoulder. while the car is off i could switch gears, but when i turn it on, no can brah! clutch doesnt seem to be grabbing. the clutch doesnt get stuck or anything, it feels really soft like its not connected but it does return when it is pressed. had it towed home. when i took a closer look the steel braided line was not connected to the master cylinder. checked the return spring and it seems fine just squeeks alot when the clutch is pressed. thinking it was the master cylinder i rushed out and bought one and installed it....still the same...cant change gears, but the car can turn on. could it be the slave cylinder?? brah i dont know what could be the problem...need help?? any ideas braddahs??

 

WTF is "braddahs" and "brah"? If ur trying to say brothers and bro...stop.

good luck on ur tranny

 

i can't even take you seriously

 

eh Howzit, the line wasn't connected at the master cylinder?

 

yea the line wasnt connected to the master cylinder, but i bought a new master and installed it and reconnected the line...still nothing..still cant change gears...what you think brah? dumb ah da haoles here

 

You're the one who can't figure the problem out.

 

and? haha funny ah da haoles here always like fight hahaha cannot even help da braddah out, typical attitude, gotta grow up braddahs

 

I'll bet he's from Hawaii.......
aint that right hynSS?

haoles = people who aren't from Hawaii.
brah = term for 'bro'

Sorry I cant help you out hynSS, I did live on Oahu for 5 years awhile back....

 

you got it brah!! cannot be the master cause i just put in a new one...maybe the slave...maybe air....i dont know anybody had this happen before???

 

You've got to remember we are all not from HI, this is a world wide site and everyone needs to understand what you're trying to tell us. I've even been to HI twice and I've never even heard that.

 

anykine...so no one knows whats the problem??? cant be the master cause its new...so i dont know

 

you stey get some air inside. bumbye I learn you how

lol

 

WTF is this the thread for the speaking inpaired? Not trying to be a dick but you gotta see what everyone is trying to tell you.

 

lol ok here goes
It sounds like there is still some air in the system and you need to dleed it out. this may take a whie

hows that?

howz dat?

 

Ya'll can understand him....stop giving him trouble.

Is 'ya'll' normal english? No......but everyone hears it.....same with his 'brah', atleast where he's from......
sheesh guys........

 

Definitly get a mity-vac and bleed the **** out of it! I'd be suspicious as to why your line came off your master

 

if its new then it must have been changed recently, im guessing the roll pin wasn't installed correctly, or at all.

 

now that's a thought

 

yeah but if the rollpin wasnt there at all, you would think it would have blown off instantly the first time you pressed the clutch...But you're probably right