Mandrel Bending Exhaust Shop, near Plainfield or Itasca
#21
and 41...that place will be a skating rink till the first scc...most likely try Bryon first...
#23
#24
it is coming along just waiting on my pushrods probably have them this week...ordered them through my uncle some trends...engine is back in the car too...dyno/tune date is the 15th...
and 41...that place will be a skating rink till the first scc...most likely try Bryon first...
and 41...that place will be a skating rink till the first scc...most likely try Bryon first...
#28
#30
will do gotta make some ra's this week but I plan to get it all back together and give it a test start this weekend if everything goes as planned...
I could always use a hand...free beer too
I could always use a hand...free beer too
Last edited by chrs1313; 03-01-2010 at 06:17 PM.
#31
I am free this saturday till 5.00 so earlly morning till 5 i can help drink your beer and maybe i can get out of my plans
#33
#34
#35
#36
ya I got another trans so that's fine, dropping it off for an ultrabell today or tomorrow. Pat G spec'd me a cam and said it was worth 15rwhp if I milled the heads and ran a thinner gasket so I was looking into getting that done, but I'd have to flycut then. Still be only 11.1:1 after the flycut since I'm running a LQ4 motor. Hopefully it runs alright, guess we'll see.
#37
ya I got another trans so that's fine, dropping it off for an ultrabell today or tomorrow. Pat G spec'd me a cam and said it was worth 15rwhp if I milled the heads and ran a thinner gasket so I was looking into getting that done, but I'd have to flycut then. Still be only 11.1:1 after the flycut since I'm running a LQ4 motor. Hopefully it runs alright, guess we'll see.
Nice I Hope the cam and trans works out great for you. We need to get a good group of cars out for a track opening day...
#38
Opening day, probably not Doubt I'll have the funds available to finish everything by early april. We'll see anything is possible....about 2 more weeks out on my cam being shipped then I can really get going.
#39
Chris you have a spare head to do the flycutting with? I might just stop out with the shortblock then shortly and have you do it. Or wait the 2 weeks, if you had the cam degreeing stuff as well?
#40
yeah I have a set of 241s that have the valves pulled...I also have all the degree stuff too...