Matching cam to factory heads
03-05-2015, 02:53 PM
#42
Teching In
Thread Starter
Join Date: Aug 2012
Location: Kansas City area
Posts: 31
Likes: 0
Received 0 Likes
on
0 Posts
The cam is in and the car is running. Here is a video of it starting up and backing into the garage. I was alone, so forgive the camera position.
03-09-2015, 03:04 PM
#43
Teching In
Thread Starter
Join Date: Aug 2012
Location: Kansas City area
Posts: 31
Likes: 0
Received 0 Likes
on
0 Posts
Mr_Hende
I have not had the car on a dyno, but I will say that I can't feel that any power has been lost down low. Mid range feels way better and It keeps going until I have to shift. Frost raised the rev limiter to 6800. I haven't been up there yet, but I know the cam will keep pulling. I'm still getting used to it. I'll post another video of me getting onto the highway. You'll notice quite a bit of wheel spin, so I have to feather it in first. I ran it up to 100 here. I was alone, so pardon the camera position.
I have not had the car on a dyno, but I will say that I can't feel that any power has been lost down low. Mid range feels way better and It keeps going until I have to shift. Frost raised the rev limiter to 6800. I haven't been up there yet, but I know the cam will keep pulling. I'm still getting used to it. I'll post another video of me getting onto the highway. You'll notice quite a bit of wheel spin, so I have to feather it in first. I ran it up to 100 here. I was alone, so pardon the camera position.
