Ricks99ls1

iTrader: (9)

Ok everyone, in the next two weeks, i am going to be doing my cam install, i am thinking of going with the 228/228/112lsa, anyhow i am just doing springs, pushrods and was looking at doing the pulley along with it, with the mods in my sig, what do you guys think i will dyno?

mook99ta

iTrader: (3)

380hp

teke184

iTrader: (5)

what's the lift?

but i tend to agree...380-390rwhp depending on tune

texasheat

I have that cam...check my sig.

John02Hawk

iTrader: (4)

365rwhp without a tune, 390rwhp with a tune

Detoxx03

iTrader: (14)

380ish is about right depending on the tune

bmxer8699

iTrader: (16)

385 id say with a good tune.

SHINER

iTrader: (18)

id say 395rwhp

Ricks99ls1

iTrader: (9)

awesome, the tune will give me a good amount of extra horse huh? it says that cam is uaually good for 35-40 horse, i appreciate the responses

SHINER

iTrader: (18)

i dunno typical cam gains on a M6 LS1 have been see any where from 50-85 rwhp

LrngCrv

The above posts are about the max you should expect though. Don't be upset if it is a little lower.

BriancWS6

iTrader: (18)

My buddy bought a car from a member on here with that cam. He doesn't have an LS6 intake, ported TB, or under-drive pulley, and it made 367rwhp/355rwtq. I would think you'd be in the 390 range. What power are you making now?