hit the rev limiter did u screw anything up??
#1
Launching!
Thread Starter
iTrader: (19)
Join Date: Jun 2006
Location: arkansas
Posts: 217
Likes: 0
Received 0 Likes
on
0 Posts
hit the rev limiter did u screw anything up??
i floored my car last night from a dead stop and had it down in 1st gear and i hit the rev limiter in 1st and 2nd pretty hard. i dont hear a knocking in the motor and the car seems to be okay, but do u guys think i screwed anything up in the process?? hope not
need suggestions
need suggestions
#3
On The Tree
iTrader: (11)
Join Date: Mar 2007
Location: Wilmington, NC
Posts: 198
Likes: 0
Received 0 Likes
on
0 Posts
The rev limiter is there to protect you from damaging stuff. Unless you did a mechanical over-rev then you should be fine. (IE going from the top of third gear and instead of powershifting 4th you go into 2nd gear).
Trending Topics
#9
TECH Apprentice
You're worried about hurting your engine? If that's the case, we all need to stop going to the dragstrip, lmao. Nah man, your engine should be fine, cause you said you hit your limiter hard in 1st. and 2nd. and it's still running good, you're good to go. The 1 thing I always do after running my engine hard, is test drive it through the city n highway like if I was regularly driving it. I turn the radio off and listen to see if I hear anything or if it's running abnormal. Then when I get home, I check the oil. A lot of cars like eating a little oil when driven hard.
#11
When you start making real power, and your on a street tire get used to kissing that rev limiter like its going out of style
Its there to protect you engine from over reving, so it does it job
Its there to protect you engine from over reving, so it does it job
#12
lets say you are shifting really fast and are going to shift into 4th but slam it into 1st, then thats going to be a problem there and maybe some bent pushrods or worse
But flooring and loosing traction and bouncing off the limiter is fine, miss shift any car and it could be bad
#16
TECH Addict
iTrader: (8)
lets say you are shifting really fast and are going to shift into 4th but slam it into 1st, then thats going to be a problem there and maybe some bent pushrods or worse
But flooring and loosing traction and bouncing off the limiter is fine, miss shift any car and it could be bad
But flooring and loosing traction and bouncing off the limiter is fine, miss shift any car and it could be bad
135R
246
Last edited by kyles2000z; 10-15-2007 at 12:13 PM.
#20
i floored my car last night from a dead stop and had it down in 1st gear and i hit the rev limiter in 1st and 2nd pretty hard. i dont hear a knocking in the motor and the car seems to be okay, but do u guys think i screwed anything up in the process?? hope not
need suggestions
need suggestions