Making a rear hump mount...
#2
Teching In
Join Date: Jan 2009
Location: Havelock, NC
Posts: 22
Likes: 0
Received 0 Likes
on
0 Posts
hey it’s not too hard to make your own mount I did it I just used some ¾” wide aluminum rod bent it around the bottle and put a hole in the top to run a bolt through so I can tighten the bracket around the bottle I can send you a pic if you like.
#6
11 Second Club
iTrader: (32)
Join Date: Jan 2006
Location: Southaven, MS (near Memphis, TN)
Posts: 3,701
Likes: 0
Received 2 Likes
on
2 Posts
Honestly, all the homemade ones I've seen were kind of ugly...So I went with the one from NitrousOutlet.
(No offense meant to anyone who built their own, sorry)
(No offense meant to anyone who built their own, sorry)
#7
none taken, i have the opinion he has about the 80 bucks, yeah it looks cool, but so does ingenuity!!!
i just bought some 1/8 aluminum, 1 1/2 wide. and bent them in a metal brake. the tops are 6 inches wide and the legs going down are 8 inches in front and 9 inches in the rear, and i was able to use the seatbelt bolts for the rear and just lagged the front. also, pics were taken with a cell phone.
and one with the seat in!!!
i just bought some 1/8 aluminum, 1 1/2 wide. and bent them in a metal brake. the tops are 6 inches wide and the legs going down are 8 inches in front and 9 inches in the rear, and i was able to use the seatbelt bolts for the rear and just lagged the front. also, pics were taken with a cell phone.
and one with the seat in!!!