If I arm my system and then click the WOT switch should I be able to hear the solenoid opening? I cant hear a thing. I can hear a click with the purge though

 

Yes you should.

 

agreed

 

Dammit

 

unless u have a window switch in the system

 

I do have a window switch. So i guess I have to just try it out?

could i set my window switch to zero RPMS and have it open the noid?

 

sure can

 

Sounds like that should work. Just curious, what window switch are you using and how is it wired to get your RPM?

 

Im using the nitrous outlet dual digital. Its wired from the coil pack, which i guess runs over to the PCM. I didnt wire it up so I cant tell you and exact answer. We were going to tap into the PCM but Nitrous Outlet said to do it that way

 

Dont set it to Zero, I think thats messes up the system. Just give them a call to find out how to test, most people will just disconnect the lines from the intake and put them in a bucket and then hold the car at activation RPM and press the WOT switch. But yes the Window switch is keeping you from testing it, Its only doing its job, it dosnt know that the car isnt running it just reads 0 RPMs and obviously wont let the system activate.

 

Ok nice ill just wait till i get the bottle filled and see what happens lol

 

you can set it to zero and activate it real quick. that is how it says to check the system with the microedge. just make sure you do it for a second because there is nothing cooling the solenoids and they will burn up.

 

he's not using a microedge, there were posts about the nitrous outlet unit locking up trying to use this technique. They had a revised version that wasnt affected by it, so depends on which one he's using

 

i was just saying that it says that you can do it like that. i dont know about the window switch he is using though. guess you will find out when you hit it then.