Finally got a clean pass on the NX MAF plate. I made a hit last week to the 1/8 on .044/.024 on both stages. First stage was set to 0 delay, 30% start, build to 1.0. Second stage turned on 100% at 1.0. Ran a lazy 6.76. I say lazy because it felt much smoother than my nozzles had. I did leave in the kids car seats and floor mats on this pass.

Last night I pulled out the floor mats, kids seats, and junk in the back like normal.

15 PSI cold in the MTs
18 degrees total timing
B8efs plugs at .030

First stage was .047/.024, 0 delay, 30% start, .6 build
Second stage was .053/.028, 100% on at .7

DA: 571

60: 1.4698
330: 4.2191
1/8: 6.5558
mph: 106.46
1/4: 10.2867
mph: 129.35

 

I do love the NX MAF kit.

 

Very nice times. 4L60E?

 

Yes 4l60e with hd2 kit and deep truck pan. 10 bolt too.

 

Does it run out of gear in the 1/4 with those 3.73s?

 

No its about perfect. 3rd gear is topped.

 

Nice times man. Work on leaving with more % on the hit. It all depends on you suspension and tire. I also saw you are still on a 10 bolt so maybe you don't want to. Lol

 

Good times! Let me know if you need anything else on our end.

-Garrett

 

Thanks. Already turned the build time down and the upper window higher.

 

Sounds like that thing is truckin right along boss. Simple *** combo running a big number.

 

Thanks for the compliments guys. Stuck an .053 jet in the first stage as well. Going to tune this setup and let it be.