View Poll Results: where should i put the bottle
Voters: 764. You may not vote on this poll
where to mount bottle
#41
Originally Posted by rebersole2
Just been reading the thread, and in the nick of time. I have just purchased my first Nitrous kit and I am about to mount my bottle sometimes this week. I was going on the back hump behind the rear seats, but never thought about the fuel tank one time. Now I will mount it on the driveshaft hump for sure. Thanks for being on time. THIS IS HOW FATE HAPPENS.
#47
i custom fabed a bracket in the spare tire well after seeing the 860 bracket
very simple to make you could get yourself some quater in thick aluminum or you could do what i did and find a street sign and cut it in half. then all you need is some 1/4 inch rubber and some steel L brackets. after that you just need patience in drilling the correct holes for mounting and for the bottle.
very simple to make you could get yourself some quater in thick aluminum or you could do what i did and find a street sign and cut it in half. then all you need is some 1/4 inch rubber and some steel L brackets. after that you just need patience in drilling the correct holes for mounting and for the bottle.
#52
Originally Posted by FSTLS1
Here's my setup. I used the bottle mount plate from Nitro Dave and just ran my lines through the grommets under the rear seats.
Thats nice.
Will it pass tech? I want mine on the hump but if it wont pass tech then I guess its the tire well
#54
Originally Posted by BFate
Spare tire well
#55
Originally Posted by 2mffZ28
Thats nice.
Will it pass tech? I want mine on the hump but if it wont pass tech then I guess its the tire well
Will it pass tech? I want mine on the hump but if it wont pass tech then I guess its the tire well
#56
Originally Posted by 99blancoSS
no tech here either with the blow off inside the car. You need the blow off to be routed outside the car. I put mine in the tire well and used a bulkhead. I'll snap a pic and post. Also you dont want your bottle laying flat like that. You want the front end higher to keep the pick up at the bottom of the juice supply. Like on the hump. See how its tilted.
#58