Nx Maf -dual Feed Single Stage
Thread Starter
10 Second Club
iTrader: (2)
Joined: Dec 2004
Posts: 1,386
Likes: 1
From: Sumter, South Carolina
I wonder if any one has used the NX MAF (w/o integrated solenoids) with both N20 lines and both fuel line T'd off single solenoids in a single stage setup. In other words have single outlets from the nitrous and fuel solenoids going to T fittings and off to the 2 inlets on the MAF housuing on each side? In a similar fashion as the TNT F1 kit(?). For a 150 shot the jets would be 2 x 75 shot for each nozzle. Any reason NOT to experiment with this setup?
I am not a NX expert, but sounds like it should work fine. Similar to a lot of the wet dual nozzle kits. As long as your noids are big enough, as some of the noids on the maf kits use the smaller noids.
Robert
Robert
Closed ex-Sponsor Account
iTrader: (1)
Joined: Jul 2004
Posts: 2,797
Likes: 0
From: Wichita Falls, TX
Originally Posted by Macon
I wonder if any one has used the NX MAF (w/o integrated solenoids) with both N20 lines and both fuel line T'd off single solenoids in a single stage setup. In other words have single outlets from the nitrous and fuel solenoids going to T fittings and off to the 2 inlets on the MAF housuing on each side? In a similar fashion as the TNT F1 kit(?). For a 150 shot the jets would be 2 x 75 shot for each nozzle. Any reason NOT to experiment with this setup? 
Ricky Thread Starter
10 Second Club
iTrader: (2)
Joined: Dec 2004
Posts: 1,386
Likes: 1
From: Sumter, South Carolina
Originally Posted by NXRICKY
150 is 150. The Maf will work as a twin nozzle set up.
Ricky
RickyTrending Topics
Thread Starter
10 Second Club
iTrader: (2)
Joined: Dec 2004
Posts: 1,386
Likes: 1
From: Sumter, South Carolina
Originally Posted by NXRICKY
As always Mr. Macon you are welcome. So whens the new dynoing happening.?
Ricky
Ricky

Oh yea...what a Mullet?
Last edited by Macon; Feb 25, 2006 at 09:51 PM.
Thread Starter
10 Second Club
iTrader: (2)
Joined: Dec 2004
Posts: 1,386
Likes: 1
From: Sumter, South Carolina
Originally Posted by Robert56
C'mon, Macon, quite being a wuss. A couple more noids, a controller and 150 to each side and bingo a dual stager.
Robert
Robert
Thread Starter
10 Second Club
iTrader: (2)
Joined: Dec 2004
Posts: 1,386
Likes: 1
From: Sumter, South Carolina
Originally Posted by Robert56
Cool, sorry I pissed you off Macon, wasn't my intent.
Robert
Robert
Originally Posted by Macon
Soon...soon...I'm a show off. Now if I can get my car to look as clean as yours!! 

Teasers soon to follow on 3rd stage.
Hawk

