FJO Progressive Controller - Problem
Just finished my N2O install and for the final step I need to program my FJO controller. I installed the software on my laptop per the instructions and connected to the controller. I get an error message on my laptop "Com 10 is in use, please choose another port". Any of you get this message? If so, what was the fix?
I e-mailed FJO tech support yesterday afternoon and haven't heard from them as of yet.
Any insight is greatly appreciated.
Cheers,
BS
start>settings>control panel>system>hardware>device manager>ports
Last edited by wyndzer; Sep 14, 2006 at 09:09 PM.
Ricky
Thanks. I don't have the car right now as it's in the shop for a bunch of engine work but, I will ping you in a few days once I get the car back. I really appreciate the assistance.
BS
Start
control panel
system
look for the ports folder. find out what is holding port 10. look at the fjo file in ports folder. It should not be yellow, red, !, ? or a cross throu it.
If it does then uninstall and reinstall...
Ricky
Not sure when the car will be back in my garage though. As far as the Com 10 problem goes, When I look in my device manager, it shows the controller on Com port 10 is enabled and working properly that is what has me a bit baffled.
Trending Topics
The Best V8 Stories One Small Block at Time

