Stand alone fuel system FS!!!
Thread Starter
8 second mod
iTrader: (37)
Joined: Nov 2002
Posts: 17,879
Likes: 1
From: East Side Performance! mASShole
Stand alone fuel system FS!!! Its a 1 gal fuel cell, all fittings, roll over valve,caps, ground ect ect.
holly 14 psi pump
straps for cell, mounting bracket for pump.
-6an braded lines to regulator.
Holly, polished regulator with all fittings needed
this setup takes the place of the batery and over flow.
i mounted a nice lightweight alum can for an overflow, and put it in the spare tire compartment. looks good, saves weight.
anyway, this system requires very little cutting ect.
small cuts to make cell fit unless you mount it high. i cut mine so it sits nice and low, looks nicer IMO
horn would need to be moved a few inches or removed.
the way its set up is the pump mounts right to the existing threaded hole for the horns, then 2 straps on the cell hold the rest. its solid!!!!
i can make the line from regulator to what ever, (y block, noids ect, just need to know how long.
the regulator comes with line that will alow you to mount on the wheel well, or front rad suport what ever you like better.
Make a reasonable offer on this. It cost about 600 to build with all the fittings ect!
you can see the cell in this pic, but its set up for dual stage (which i can also sell it like that if you want, regulators mount on the pass side head to existing holes
Not a good pic, but it shows how low i have it sitting, looks very clean!!!!!!
this pic is last year with 1 stage set up.
you can see the regulator under the red one. the system would come with a new one tho. you can see the caps, fittings, down tube ect in this pic also.
holly 14 psi pump
straps for cell, mounting bracket for pump.
-6an braded lines to regulator.
Holly, polished regulator with all fittings needed
this setup takes the place of the batery and over flow.
i mounted a nice lightweight alum can for an overflow, and put it in the spare tire compartment. looks good, saves weight.
anyway, this system requires very little cutting ect.
small cuts to make cell fit unless you mount it high. i cut mine so it sits nice and low, looks nicer IMO
horn would need to be moved a few inches or removed.
the way its set up is the pump mounts right to the existing threaded hole for the horns, then 2 straps on the cell hold the rest. its solid!!!!
i can make the line from regulator to what ever, (y block, noids ect, just need to know how long.
the regulator comes with line that will alow you to mount on the wheel well, or front rad suport what ever you like better.
Make a reasonable offer on this. It cost about 600 to build with all the fittings ect!
you can see the cell in this pic, but its set up for dual stage (which i can also sell it like that if you want, regulators mount on the pass side head to existing holes
Not a good pic, but it shows how low i have it sitting, looks very clean!!!!!!
this pic is last year with 1 stage set up.
you can see the regulator under the red one. the system would come with a new one tho. you can see the caps, fittings, down tube ect in this pic also.
