Cutout Switch to Opener Switch?
#1
Thread Starter
12 Second Club
iTrader: (7)
Joined: Oct 2005
Posts: 1,018
Likes: 0
From: Englewood, CO
Cutout Switch to Opener Switch?
Ok, i have the qtp cutout switch. i got the switch panel for my nitrous from dave, and i am trying to make the switch for the bottle opener work for my cutout. the new switch has 6 pins, and the old one has 8, all used. how do i wire this up?
#5
Note: little black dots are connection points, if there is no black dot and wires intersect then there is NO connection there.
First off there should only be 2 wires coming from the cutout. In the image above its the largest black wires coming from the cutout with connection points A & B.
Lets start wiring:
•12volt supply will go to the pin #2
•Ground will go to pin #5
•Pin #1 and #6 will be connected together to cutout wire A
•Pin #3 and #4 will be connected together to cutout wire B
•Thats the end of it!
Is it understandable now?
#7
Originally Posted by 99_Z_155
yeah. i understand that now. its just i dont know what cutout wires A and B are that are currently on the stock qtp switch.
If you could post pics of the wiring harness I may be able to help more.
Trending Topics
#12
Originally Posted by frknlo
Note: little black dots are connection points, if there is no black dot and wires intersect then there is NO connection there.
First off there should only be 2 wires coming from the cutout. In the image above its the largest black wires coming from the cutout with connection points A & B.
Lets start wiring:
•12volt supply will go to the pin #2
•Ground will go to pin #5
•Pin #1 and #6 will be connected together to cutout wire A
•Pin #3 and #4 will be connected together to cutout wire B
•Thats the end of it!
Is it understandable now?
I have a DMH cutout and had to make a daisy chain type harness to make the two wires from the cutout motor into four.