NOS plate kit test question.
Thread Starter
Launching!
Joined: Sep 2007
Posts: 230
Likes: 0
From: Surrey, BC
NOS plate kit test question. I just installed a NOS plate kit on my 2000 Trans Am WS6. I don't have the bottle in the car yet, so to make sure the fuel side of things was set up correctly I engaged the system (above 3k RPM) and I assumed it would spray fuel only and run really rich, and suck ***. However it only did this for a second or two before resumeing normal opperation (still at WOT). Could this be because the computer recognized the super rich condition and pulled fuel from the fuel injectors? Would this have anything to do with the nitrous solenoid still being hooked up (electrically, hose from the solinoid conected to the plate and a plug in the nitrous in hole).
Is this what should happen? I just wanted to make sure before I hooked up the bottle.
The car is a stock M6 asside from the nitrous system.
Is this what should happen? I just wanted to make sure before I hooked up the bottle.
The car is a stock M6 asside from the nitrous system.
12 Second Club
Joined: Feb 2006
Posts: 170
Likes: 1
From: Las Vegas
Better check your fuel solenoid. See if it is engaging. With the engine off and the arming swith on engage your wot switch and listen for your fuel solenoid to make a clicking noise. Mine runs really crappy when the bottle runs empty. It starts popping and backfarting.
Originally Posted by MyTA99
Better check your fuel solenoid. See if it is engaging. With the engine off and the arming swith on engage your wot switch and listen for your fuel solenoid to make a clicking noise. Mine runs really crappy when the bottle runs empty. It starts popping and backfarting.
i didn't notice a difference when i had my bottle off and armed the system with a 100 shot of extra fuel. with the 150 shot fuel jet in and the bottle off, it backfired, bogged, and ran real bad when i armed the system with the kit just spraying fuel.
Thread Starter
Launching!
Joined: Sep 2007
Posts: 230
Likes: 0
From: Surrey, BC
Checked the fuel solenoid, all is well. I still need to mound the bottle (when it stops raining). This momentary bog and then normal opperation at WOT just spraying fuel is normal then?
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo
Awesome K5 Blazer Restomod Comes With C7 Corvette Power
Verdad Gallardo
10 Camaros You Should Never Buy
10 LS Engine Myths That Refuse to Die
Verdad Gallardo
Staging Lane
Joined: Mar 2007
Posts: 74
Likes: 0
From: Canada
Originally Posted by scottHMT
mine has does the same thing aswell, feul doesnt really squirt out unless it has the nitrous pressure to help it spray everywhere
Later,
Brad
Last edited by PistonHead; Sep 27, 2007 at 11:26 PM.
I just installed a NOS plate kit on my 2000 Trans Am WS6. I don't have the bottle in the car yet, so to make sure the fuel side of things was set up correctly I engaged the system (above 3k RPM) and I assumed it would spray fuel only and run really rich, and suck ***. However it only did this for a second or two before resumeing normal opperation (still at WOT). Could this be because the computer recognized the super rich condition and pulled fuel from the fuel injectors?
thats normal, mine only bogs for a second, then i guess the pcm must fix it.
it took me a while to figure that one out, had me worried untill i got a Fuel Pressure gauge to watch it 1st hand
Thread Starter
Launching!
Joined: Sep 2007
Posts: 230
Likes: 0
From: Surrey, BC
