sweet-94z28

iTrader: (30)

I have a 1994 Z28 M6 that I am going to part out. The car is Black with dark gray interior. Everything is up for grabs, this is a total part-out. Everything is priced without shipping unless noted otherwise. All prices are OBO. Here are some of the things I can think of off the top of my head:


POWERTRAIN:

-Custom 3" True Duals, summit x-pipe kit, moroso spiralflow mufflers, turndowns before the axle, comes with hangers and band clamps - $400 (sound clip: http://www.youtube.com/watch?v=sgnhpel4foU)

-Alternator, works great, 140 amp, 77K miles - $40 *Sale Pending*

-Starter, 77K miles - $30 *Sale Pending*

-Mass Air Flow Sensor, no screen - $40

-M6 Wiring Harness - $80 *Sale Pending*

-M6 computer, stock tune - $75

-AC setup, will send everything including condenser, evaporator, compressor, and all lines - *Lines have been SOLD. Will sell remainder for $75 *SALE PENDING*

-PS Pump and Lines - $50

-Water Pump, 160 thermo with about 5K on it included, about 20K miles, works great - $50

-Intake (gasket matched) - $150

-Stock Throttle Body, has all sensors on it - $25

-Stock Intake Elbow, great shape, donkey thing plugged, a small rip under where it clamps on TB but still seals up, comes with IAT sensor - $20

-Stock Intake Elbow, like new, one tiny tear along TB clamp, but will still work great - $20

-Polished LT1 Fuel Rails with stock injectors - $50 *SALE PENDING*

-Heads, complete 374 casting - $275

-1994 Shortblock, with stock cam and lifters, no issues or noises, 65-70 oil PSI cold and 40 hot on 10w30 - $300

-Complete T56 swap setup, was rebuilt earlier this year by an ASE world certified transmission specialist, has about 1K miles on the rebuild, comes with Sachs Stage 2 clutch kit (1K miles as well, and it is really smooth and it bites really well. Sachs is a sister company to ZF of Germany that made the ZF 6 speed for the corvette.), spec billet flywheel, pedals, stock shifter, M6 console surround, and all new hydraulics that were installed with the rebuild, over $2K invested in rebuild and everything - $2000

-3.42 M6 rear axle, posi locks up good still, 3 channel ABS - $250 without brakes or $350 with brakes (new calipers and almost new pads and rotors) *PICKUP OR DELIVERY ONLY*

-Steel Driveshafts, I have 2, both out of M6 cars, good u joints, $50 each

-LT1 Automatic radiator, great shape, no leaks - $50

-K&N Cold Air Intake setup, just cleaned the filter, like new - $150

-LT1 ignition module and coil, I have 2 - $50

-Power Steering rack, comes with all linkages and the rag joint - $50

-Stock Torque Arm - $10

-LT1 Accesory Bracket - $25

-All of the smog stuff I have - $20

-LT1 Belt Tensioner - $15

-ABS module - $20

-Brake Master Cylinder - $25

-Power Brake Booster - $25

-Harmonic Balancer - $50

-Crank Hub - $30

-94 Optispark, I know optical part works, used with delteq - $30

-Valve Covers with bolts - $25

-Oil pressure sending unit - $5

-LT1 Throttle Cable (w/o ASR) - $25

-Cruise Box, works - $15

-Front Sway Bar - $20

-Flowmaster 80 series muffler - $50


WHEELS:

-4 Silver Pontiac ABS wheels, without tires, nice shape - $150 *SALE PENDING*

-4 Silver Pontiac ABS wheels, Cooper Cobra 235/55/16 tires, 2 with 25% and 2 with about 50% - $200 *SALE PENDING* *PICKUP OR DELIVERY ONLY*

-4 extremely clean salad shooters, with center caps - $100


INTERIOR:

-Dark Grey Door Panels - $80 pr.

-Dark Grey Driver's side door panel - $40

-Dark Grey Rear Hatch plastic - $20

-Dark Grey Sail Panels - $50

-Dark Grey Spare Tire Cover and Opposite side with Bose Speaker hole - $25 pr.

-Dark Grey Kick Panels - $25 pr.

-Red and Black Cloth Racing Seats with tracks - $150 *PICKUP OR DELIVERY ONLY*

-Center Console in great shape with an Unbroken Lid! - $100

-DVD player and an LCD screen that fits over the storage hole below the radio, work good - $100 *SALE PENDING*

-Window switches and everything for the mirrors and locks, all work great and the little thing actually stays in place - $30 for the driver's side, $20 for the passenger side *SALE PENDING*

-Door Handle surrounds, good shape - $25 pr. *SALE PENDING*

-Dash Switches and Controls - $50 for all *SALE PENDING*

-Gauge Bezel - $20

-Padded Dash section - $50

-Driver's air bag and steering wheel, center is split a little, but never blown - $25

-Passenger side air bag - $40

-Steering Column - $50

-Cover below steering column - $20

-Dome Light - $20

-Rear View Mirror - $20

-Headliner, falling a little - $40

-T-top A-Pillars -$25

-Rear T-top mount covers - $15

-Pioneer Head Unit, a few years old but barely used, one of their "upper" models - $100

-JL Audio speakers, one for all 4 normal spots - $60

-JL Audio sub that fits in the Bose sub box - $20

-Radio Surround Panel - $15

-Glove Box, new latch in it - $25


EXTERIOR STUFF:

Front Bumper, needs painted, decent shape - $40 *PICKUP OR DELIVERY ONLY*

Hood, has a little rust under the front edge - $20 *PICKUP OR DELIVERY ONLY*

Hood struts, work good - $10

Rear Hatch Struts, work good - $25

Front fenders, both are cracked at the bottom - Make offer.... *PICKUP OR DELIVERY ONLY*

Front Inner fenders - $25 each

Front re-bar and styrofoam absorber - $50 *PICKUP OR DELIVERY ONLY*

Driver's Door, has all the window tracks, window, and motor in it - $75 *PICKUP OR DELIVERY ONLY*

Amber Front Turn Signal Lights, great shape - $20 pr.

Front Headlight bar, complete with headlights and buckets - $75

Washer Fluid Tank - $15

Rear Sidemarker lights - $20 pr.

Berger Panel, black with original Z28 emblems on it - $40

Fog Lights with brackets - $75

Wiper Arms - $30 for both

Wiper Motor - $25

Cowl Plastic - $30 for all

Outside mirrors - $25 each

Rear Bumper Cover - $50 *SALE PENDING* *PICKUP OR DELIVERY ONLY*


WHATS LEFT:

1994 Z28 roller, has some rust, needs body work, 175Kish on the body, good suspension, comes on a set of salad shooters - $400 without a rearend, $700 with a rear end in it.


I'm sure I'll be adding more to this list as time goes on. I have many pictures of the car and the parts. I have a video of it running yesterday. Tonight I am going to start tearing it down. Remember, the prices are just a starting price. Make some offers, gotta move this stuff fast!!!

WildRidez

iTrader: (3)

Pacesetter Painted Race Longtubes, fresh coat of VHT paint - $175

Got any pics? I am interested in those.. how many miles you think on them? You dont happen to have an uncracked dashpad do ya? In need of one of those also.

Will take the starter as well... 50 shipped?

91ZLS6

iTrader: (2)

Would you do $120 shipped for the CAI? Let me know ASAP!

93-Z/28

You willing to separate the M6 console insert (shift plate, boot, & ashtray) from the trans package?

Let me know if so shipped to 35244...

Radcannon

iTrader: (3)

Need pedal assembly and remote master reservoir. ASAP got money in my hand and paypal. I also need the u bolt for the master. And crossmember.

sweet-94z28

iTrader: (30)

Sorry, it goes as a whole, or not at all.

chevydriverz28

Pm sent

BoostedLQ9SS

iTrader: (11)

Do you still have console, Could you send me pictures. Email: Boostinblazer92@aol.com

Shipped to Toms River, NJ 08755

Thanks
Ralph

Radcannon

iTrader: (3)

thats fine good luck then.

78novacaine

iTrader: (2)

where are you located at? may be interested in the rear end

aqwk98

What's your bottom dollar for both the window switch panels? I really don't need the switches, just the housing that hey sit in, but will buy the complete set if that's how you want to sell it. Also, will you sell the latch mechanism that goes on the end of the door and latches to the striker (It has two rods going into it from the interior dor handle)

CATCHMYZ

iTrader: (1)

Willing to sale the brackets that hold the rear brake calipers to the axle ?

355 RS

iTrader: (7)

Where are you located. May be interested in wheels

sweet-94z28

iTrader: (30)

I will sell them with the brake calipers. The calipers are brand new.

Bryan, OH 43506

355 RS

iTrader: (7)

Sorry, my brother just pickd up a set of wheels like on your T/A. Free bump tho

Xtreme864

iTrader: (15)

Might be a dumb question but do the rear berger's from the 93-97's fit on 98-02's? If so, price for rear berger shipped to 29680?

CATCHMYZ

iTrader: (1)

No i have a set of good brake calipers I just got rid of the brackets that hold them to the axle. I'm talking about the bracket that bolts behind the axle on the axle tube with 4 bolts, then the calipers bolt to it with 2 bolts.

black94formula

iTrader: (1)

pm sent

sweet-94z28

iTrader: (30)

I knew what you were talking about but at this time, I would rather keep the calipers together with the brackets for someone to be able to swap from drum to disk brakes. If something changes, I'll let you know.

I was very busy all weekend. Everything is still available except the A/C lines, Mirror Triangles, and the SLP/Hurst ****. Headers are pending. I need to get over there and get the motor all the way out and take them off.

The best pictures I have are here: http://s261.photobucket.com/albums/ii72/mickelsonn/

I can get better pics tonight of everything as it should be a rolling chassis by the end of the night.

davis7241

I think I have seen this car before...