Fresh LT1355ci shortblock built for moderate boost located in CT.
#1
10 Second Club
Thread Starter
iTrader: (27)
Join Date: Nov 2006
Location: Connecticut
Posts: 1,905
Likes: 0
Received 0 Likes
on
0 Posts
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
I have an LT1 short block out of my 96 trans am that I had rebuilt as a back up for my turbo motor. The shortblock has 0 miles on it and the following:
Block had 36,019 miles on orig. setup. and was takin apart running.
Brand new stock GM crank
Scat forged I-beams with arp 2000 bolts
SRP -24cc dished(low compression) forged pistons .030 over
plasma-moly piston rings gapped for boost
all clevite H-bearings
arp 2 bolt main studs
This is just the block and rotating assembly. Its setup to run 12-15psi from a turbo.supercharger. I have close to 3k into this setup. It has never been used and has been sitting wrapped up in my climate controlled basement since last year when I had it built. I dont have the reciepts anymore but the shop(well known around here) is about 10 min away and we can go there to get em if needed.
Im looking to get 1750 obo. PICK UP ONLY. Located in connecticut.
Block had 36,019 miles on orig. setup. and was takin apart running.
Brand new stock GM crank
Scat forged I-beams with arp 2000 bolts
SRP -24cc dished(low compression) forged pistons .030 over
plasma-moly piston rings gapped for boost
all clevite H-bearings
arp 2 bolt main studs
This is just the block and rotating assembly. Its setup to run 12-15psi from a turbo.supercharger. I have close to 3k into this setup. It has never been used and has been sitting wrapped up in my climate controlled basement since last year when I had it built. I dont have the reciepts anymore but the shop(well known around here) is about 10 min away and we can go there to get em if needed.
Im looking to get 1750 obo. PICK UP ONLY. Located in connecticut.
Last edited by Snyper; 11-02-2008 at 03:21 PM.