Vortec elbow (satin) and Moroso CAI
#1
12 Second Club
Thread Starter
iTrader: (3)
Join Date: Dec 2005
Location: C'ville
Posts: 226
Likes: 0
Received 0 Likes
on
0 Posts
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
80 shipped CAI and vortec elbow... NEW would cost you 280 plus shipping...
you will need to lengthen the iat sensor wires to reach the iat sensor that is installed in the moroso cai elbow... the metal hole that i drilled into the vortec elbow is for the opti vent, obd-2...
there was no mounting hardware... i also had to cut an inch from the moroso cai elbow because the vortec elbow was longer then the factory elbow...
you will also need two clamps or use your factory clamps (just reuse your stock elbow clamps)...
![](http://i345.photobucket.com/albums/p375/mjh97z28/Picture005.jpg)
you will need to lengthen the iat sensor wires to reach the iat sensor that is installed in the moroso cai elbow... the metal hole that i drilled into the vortec elbow is for the opti vent, obd-2...
there was no mounting hardware... i also had to cut an inch from the moroso cai elbow because the vortec elbow was longer then the factory elbow...
you will also need two clamps or use your factory clamps (just reuse your stock elbow clamps)...
![](http://i345.photobucket.com/albums/p375/mjh97z28/Picture005.jpg)
![](http://i345.photobucket.com/albums/p375/mjh97z28/Picture006.jpg)
Last edited by LTBANDIT; 08-18-2008 at 02:10 PM.