Shaved Door Handles: Yay or Nay. Lets see some pics.
#1
TECH Regular
Thread Starter
Shaved Door Handles: Yay or Nay. Lets see some pics.
I am considering shaving off my door handles but i have never seen 93+ fbodys with this modification.
Shaving the door handles would make a fbody look very sleek and clean IMO.
POST UP SOME PICS.
Shaving the door handles would make a fbody look very sleek and clean IMO.
POST UP SOME PICS.
#3
TECH Fanatic
iTrader: (9)
I think most tracks have a rule that they won't let you touch the track unless you have handles, so if you've got dreams of time slips, I wouldn't do it, but if your ride will never see a closed curcuit, go for it! I want to see how it looks! I want to shave my fuel door and antenna. I already shaved the front license plate cover! I like my cars like I like my women...SHAVED!!!
Swat
Swat
#4
I think most tracks have a rule that they won't let you touch the track unless you have handles, so if you've got dreams of time slips, I wouldn't do it, but if your ride will never see a closed curcuit, go for it! I want to see how it looks! I want to shave my fuel door and antenna. I already shaved the front license plate cover! I like my cars like I like my women...SHAVED!!!
Swat
Swat
I'm not sure how it would look.
#5
TECH Regular
Thread Starter
How hard was to shave the door handles?
#6
TECH Regular
Thread Starter
I think most tracks have a rule that they won't let you touch the track unless you have handles, so if you've got dreams of time slips, I wouldn't do it, but if your ride will never see a closed curcuit, go for it! I want to see how it looks! I want to shave my fuel door and antenna. I already shaved the front license plate cover! I like my cars like I like my women...SHAVED!!!
Swat
Swat
But i am getting tired of e/ts and the track car image. So, the 94z will be the clean street car and my lsx car will be track car.
Trending Topics
#10
TECH Regular
Thread Starter
#14
i shaved my key holes on both sides cause someone fucked up my car with a screw driver while i was at work. and i also didnt want to pay big bucks for new doors or to get the hole fixed.
still primered in these pics.
still primered in these pics.
#17
well the key holes were already punched out, so i put a piece of tape inside the door panel on the backside of the hole and used bondo to fill it in, sand it down until it was flat. then i would relay bondo down to fix imperfections and sand again. i did this process 4-5 times until it was good enough for my liking.