SBC 406 for sale. Intake to oil pan,flex plate.
#1
SBC 406 for sale. Intake to oil pan,flex plate.
I have my 406 SBC That I need to get rid of, I wanted to keep it around as a back up, but my hours got cut at work and it has to go. The only thing this motor needs is a distributor, carb, and a new intake manifold gasket. Will not come with valve covers.
Here are the specs.
Motor
400 30 over
406 Cubic inches
Cola Crank
Pink rods
TRW pistons flat top pistons
Clevite bearings
Large Hydraulic roller camshaft(will give specs to buyer) Duration 300/300
Brand new Auminum Brodix Spec 2 heads, fully ported and polished
New valves,springs,locks retainers keepers, valve seals.
Performer Edelbrock RPM intake
Moroso deep pan with trap doors
Flex plate
Comp Cams Rocker arm studs
Chromoly hardened pushrods
Comp cams Hydraulic lifters
Crank pulley
Fuel Block Off plate
Im asking $3000 firm.
The motor will be everything from intake to pan, No valve covers.
The car saw a best time this last spring of 11.65@117MPH. That is with the car weighing full weight, stock suspension,springs shocks from 1991. Stock 10 bolt rear with a stock gear, and a 2400 convertor. With a gear, suspension, and a larger convertor in athe car at the same weight, you could see low 11"s on motor. The motor was also built to handle N20.
I had never sprayed the motor(just had everything layed out) There are currently about 5,000 miles on the engine since it was put together. The motor has seen 5 track passes.
Here are some pics of the motor still in the car,The motor has been pulled.
[/QUOTE]
Here are the specs.
Motor
400 30 over
406 Cubic inches
Cola Crank
Pink rods
TRW pistons flat top pistons
Clevite bearings
Large Hydraulic roller camshaft(will give specs to buyer) Duration 300/300
Brand new Auminum Brodix Spec 2 heads, fully ported and polished
New valves,springs,locks retainers keepers, valve seals.
Performer Edelbrock RPM intake
Moroso deep pan with trap doors
Flex plate
Comp Cams Rocker arm studs
Chromoly hardened pushrods
Comp cams Hydraulic lifters
Crank pulley
Fuel Block Off plate
Im asking $3000 firm.
The motor will be everything from intake to pan, No valve covers.
The car saw a best time this last spring of 11.65@117MPH. That is with the car weighing full weight, stock suspension,springs shocks from 1991. Stock 10 bolt rear with a stock gear, and a 2400 convertor. With a gear, suspension, and a larger convertor in athe car at the same weight, you could see low 11"s on motor. The motor was also built to handle N20.
I had never sprayed the motor(just had everything layed out) There are currently about 5,000 miles on the engine since it was put together. The motor has seen 5 track passes.
Here are some pics of the motor still in the car,The motor has been pulled.
[/QUOTE]
Last edited by blown 346; 12-29-2009 at 03:09 AM.