FS: Moser 9" for your stock rearend + cash - Memphis
#1
11 Second Club
Thread Starter
iTrader: (32)
Join Date: Jan 2006
Location: Southaven, MS (near Memphis, TN)
Posts: 3,701
Likes: 0
Received 2 Likes
on
2 Posts
FS: Moser 9" for your stock rearend + cash - Memphis
I have a Moser rearend that is pretty much new...
It only has 600-700 miles on it.
Moser 9"
Detroit locker
3.50 gears
35 spline axles
iron center
drain and fill plug
UMI welded relocation brackets
NO ABS or TCS
ALSO
PST 3.5" 1000hp driveshaft
I am located near Memphis and will not be shipping this! If you are somewhere close we can arrange a meeting in PMs.
I'm looking to get $2400 for everything plus your stock 10 bolt. It needs to have at least 3.42s. (No 2.73 or 3.23) Also, it needs to be a 3 channel rearend (only ABS)
The only problem with the rearend is a SLIGHT gear noise. Which seems to happen to a lot of Mosers.
But trust me, my 10 bolt with Motive gears was a Metallica concert compared to this Moser 9"..hah It's not bad.
I just checked EPP and this same setup is $2950 and mine already has backing plates on it. So you will be saving a decent amount! Bolt in and go!
Also, I have an extra HPTuners credit and will change the gear ratio for you. (If you are local, of course..hah)
It only has 600-700 miles on it.
Moser 9"
Detroit locker
3.50 gears
35 spline axles
iron center
drain and fill plug
UMI welded relocation brackets
NO ABS or TCS
ALSO
PST 3.5" 1000hp driveshaft
I am located near Memphis and will not be shipping this! If you are somewhere close we can arrange a meeting in PMs.
I'm looking to get $2400 for everything plus your stock 10 bolt. It needs to have at least 3.42s. (No 2.73 or 3.23) Also, it needs to be a 3 channel rearend (only ABS)
The only problem with the rearend is a SLIGHT gear noise. Which seems to happen to a lot of Mosers.
But trust me, my 10 bolt with Motive gears was a Metallica concert compared to this Moser 9"..hah It's not bad.
I just checked EPP and this same setup is $2950 and mine already has backing plates on it. So you will be saving a decent amount! Bolt in and go!
Also, I have an extra HPTuners credit and will change the gear ratio for you. (If you are local, of course..hah)
Last edited by jetlag; 11-18-2009 at 06:11 PM.