Category: Engine - Complete Motors
Price: $1500
Part Fits: 93-02 Chevrolet Camaro, 93-02 Pontiac Firebird
Location (State): MI
Item Condition: Used
Engine: LS1/LS6
LS Engine?: Fits LS Engine

I have a 1998 LS1 block out of a 1998 camaro z28 that had 38k on it and was wrecked. Bottom end was torn down by a local machine shop (to check the condition of it which was great still) and had all the bearings replaced (for my peace of mind since it was apart), ls6 oil pump installed, ls2 timing chain, ARP rod bolts. All upgrades done to improve the strength and ability of engine. Stock 98 cam. Rebuild finished 12/16/09. Again nothing was wrong with the engine before the rebuild, I just bought it off ebay and wanted to make sure everything was good for when I installed it in a project car.

Heads are off the engine at the moment but have been cleaned and checked and included along with new GM MLS head gaskets. Heads are perfect. Also have stock lifters, pushrods, etc. ready to go for it and included.

Intake, throttlebody and accessories not included. Most guys go with a ls6 intake for better flow. Great for a retro build or to replace a blown engine in a 4th gen Fbody.

Planned on finding a roller to put it into, but the new house changed those ideas.
$1500 or best offer. Thanks.

P.S. Shipping would be on you to set up and pay for, would rather not ship due to size and weight.

 

free bump for a good seller!! G/L with sale.

 

thanks.

 

will this work in a 01 c5 vette? i have my old intake...and other ls1 stuff...

u can email me at halloraneric@aol.com

 

Unsure of the vette oil pans and fbody oil pans if there is a difference in them. I am not all familiar with the vette cars. The stock cam would be different than your 01 car I know that. The accessories, intake etc all bolt on just fine. Maybe someone on here will know about the oil pan if it is the same or not

 

Yes that motor will work in a 01 vette, but I would use the vettes heads being these are the perimeter bolt valve cover Heads that come on a 98 motor.

Hope that helps

Brian

 

thanks Brian for the tips

 

no prob, good luck with the sale on a nice motor

 

bump.

 

Eric,this might be a good choice for you.Nothing cheap local as of today.

 

still have it.

 

bump.

 

responded to PMs. Still have engine

 

Would you be willing to just sell the short block? If so what price would you sell it for?

 

$1450 for the block minus the heads and valvetrain. 98 heads aren't that desirable to modders so I won't be able to sell them too fast.

 

sale pending until tomorrow at 9pm. If it falls through I will let you guys know. Thanks

 

Sold!!!!!