Melrose T-Top Valve Covers w/ Stud Girdles and Comp Pro Mag's
05-19-2010, 02:40 PM
#1
12 Second Club
Thread Starter
iTrader: (35)
Join Date: Jan 2006
Location: Danville PA
Posts: 1,550
Likes: 0
Received 0 Likes
on
0 Posts
Melrose T-Top Valve Covers w/ Stud Girdles and Comp Pro Mag's Category: Engine - Intake/Fuel
Price: $500
Part Fits: 93-02 Chevrolet Camaro, 93-02 Pontiac Firebird
Location (State): PA
Item Condition: Used
Engine: LT1/LT4
LS Engine?: Non-LS Part
-Comp cams rocker arm adjusting nut with poly locks, .750 OD, ~2.5" tall for use with stud girdle.
-Aluminum stud girdle, The girdle is drilled and tapped for holding down the valve cover with supplied studs! This is a custom setup from Melrose T-top
-Custom modified cast aluminum valve covers from Melrose T-top. I just had these powdercoated. They are extra tall and made to work with the girdle studs for hold down. The one cover has been modified a bit. It was notched and welded to allow for alternator clearance. NO ALTENATOR RELOCATION NEEDED The modification is very subtle and if you weren't looking for it you wouldn't even see it.
The rockers are used but have alittle over 1000 miles total on them. They are in brand new condition! I paid alot of money for this setup. This is just about the best valvetrain set up you can buy without going to shaft mounted rockers.
SOLD!!!
PICS
Last edited by Schweet97Z; 06-11-2010 at 01:40 PM.
Trending Topics
06-09-2010, 11:33 AM
#11
12 Second Club
Thread Starter
iTrader: (35)
Join Date: Jan 2006
Location: Danville PA
Posts: 1,550
Likes: 0
Received 0 Likes
on
0 Posts
Willing to trade for guns, 4 wheeler parts (Specifically Yamhaha Banshee), tools, and anything else that you think might spark ones interest. Need these gone. Have no use for them anymore.
