LT1 House of Boost Cog bracket
#1
TECH Enthusiast
Thread Starter
iTrader: (1)
Join Date: Apr 2005
Location: Colorado
Posts: 639
Likes: 0
Received 0 Likes
on
0 Posts
LT1 House of Boost Cog bracket
Category: Racing Parts
Price: $600
Part Fits: 93-02 Chevrolet Camaro, 93-02 Pontiac Firebird
Location (State): AL
Item Condition: Used
Shipping Information: Item Can be Shipped
Engine: LT1/LT4
LS Engine?: Fits LS Engine
With a huge wide range of belt pulley combinations, and supercharger models supported, this system offers something for almost any ProCharger user. Although House of Boost does not recommended to cog drive any ProCharger smaller then a “F1” series, the mounting locations for smaller superchargers are supported. F1-C and F1-R superchargers will require mild block modifications for clearance, and minimal space is available for inlet system. (F1-R, will require frame notching for discharge clearance) Recommended on “Race Only” applications.
I have decided to sell my House of Boost cog drive system for the LT1. It is in fine working condition and will include a gates belt, crank and blower pulley, as well as the new ATI idler pulley with the smaller shoulder on it to keep it from interfering with the blower pulley..With this pulley combo I make around 10 psi at 5600 feet above sea level, so figure more for lower elevations. Brand new kit is 1150, will sell this one for 900 + shipping.
Last edited by My2kz28; 04-10-2011 at 10:07 AM.
Trending Topics
#9
TECH Enthusiast
Thread Starter
iTrader: (1)
Join Date: Apr 2005
Location: Colorado
Posts: 639
Likes: 0
Received 0 Likes
on
0 Posts
lets go people i cant believe i havent sold this yet..they are 1150 new and this kit has less than 5k on it...anyone with a fseries procharger on their lt1 should run one of these, the stock ATI brackets are ****!
#11
TECH Enthusiast
Thread Starter
iTrader: (1)
Join Date: Apr 2005
Location: Colorado
Posts: 639
Likes: 0
Received 0 Likes
on
0 Posts
Selling for 600 plus shipping...somebody buy this thing already I cant believe how many LT1 guys are wasting their time with the crappy serp setup from ATI..this will solve all your SC problems!!!! I will email pics, will check pm's regularly.
#15
TECH Enthusiast
Thread Starter
iTrader: (1)
Join Date: Apr 2005
Location: Colorado
Posts: 639
Likes: 0
Received 0 Likes
on
0 Posts
No clue of this fits SBC. Ive got an old 12 rib tensioner in the garage, but i dont know if i have all the parts for it..not sure if its in good working consition as my F1a was too much for the bracket. If you want it i think ive got some more room in the box ive got everything in. But ill tell you this house of boost bracket is about 100x more sturdy than anything ATI makes...Call House of boost if you want it on an SBC.
#17
Interested, sends me pic's please. I got an LTx and am planning lots of boost. loca5790@kettering.edu