CNC/ported 5.3 706 heads w/ dual springs. 1 good 1 bad. --SOLD--
#1
TECH Fanatic
Thread Starter
iTrader: (21)
Join Date: Oct 2006
Location: Everywhere
Posts: 1,105
Likes: 0
Received 0 Likes
on
0 Posts
CNC/ported 5.3 706 heads w/ dual springs. 1 good 1 bad. --SOLD--
Category: Engine - Intake/Fuel
Price: $0
Part Fits: 2010+ Camaro, 93-02 Chevrolet Camaro, 93-02 Pontiac Firebird, Corvette, 04-06 Pontiac GTO, 04+ Cadillac CTS-V, 67-92 Chevrolet Camaro, 67-92 Pontiac Firebird, Front wheel drive vehicles
Location (State): OK
Item Condition: Used
Shipping Information: Item Can be Shipped
Engine: LS2/LS3/LS7/L92/LS9, LS1/LS6
LS Engine?: Fits LS Engine
One head is in good shape but one of the heads is cracked and would need repaired. If there is any interest in these let me know... I'll get pictures as soon as I get them in my hands.
Sold for $300 shipped on 10/02/10. Thanks!
Last edited by candlelit; 10-02-2010 at 04:29 PM. Reason: pics & price
#2
Staging Lane
iTrader: (13)
Join Date: Jul 2007
Location: laurel, MS
Posts: 68
Likes: 0
Received 0 Likes
on
0 Posts
haha $3000? your scaring people off. I have a set of tsp 98 perimeter bolt heads that are well ported and one head is easilt fixable that i would be happy if someone would just give me $150. try a lower figure if you wanna move them
Trending Topics
#8
TECH Fanatic
Thread Starter
iTrader: (21)
Join Date: Oct 2006
Location: Everywhere
Posts: 1,105
Likes: 0
Received 0 Likes
on
0 Posts
Hate to tell you all but I am no expert when it comes to heads. I'm not sure how much the mill or CC is, don't have a tool to measure nor do I have a caliper. I measured the head from bottom surface to top where the valve cover would sit with a stupid ruler and got roughly 4.69" ish. Is that number way too inaccurate? Because isn't the heads 4.75" stock, and that would be a difference of .060?? If so that's an unbelievable amount or I'm not measuring it properly.
For the crack, I looked the heads over pretty hard and could only find damage to where that one piston chewed up the head. I can see a little daylight underneath one of the valves (referencing that last picture I uploaded). Also where the bottom of the spark plug is got chewed up. Not sure if you can see it in the picture or not.
For the crack, I looked the heads over pretty hard and could only find damage to where that one piston chewed up the head. I can see a little daylight underneath one of the valves (referencing that last picture I uploaded). Also where the bottom of the spark plug is got chewed up. Not sure if you can see it in the picture or not.