F/S used AFR Small Bore 225 cylinder Heads
06-25-2011, 03:16 PM
#1
On The Tree
Thread Starter
iTrader: (18)
Join Date: Jun 2006
Location: League City, TX
Posts: 135
Likes: 0
Received 0 Likes
on
0 Posts
F/S used AFR Small Bore 225 cylinder Heads Category: Engine - Intake/Fuel
Price: $1950
Part Fits: 93-02 Chevrolet Camaro, 93-02 Pontiac Firebird, Corvette, 04-06 Pontiac GTO, 04+ Cadillac CTS-V
Location (State): TX
Item Condition: Used
Shipping Information: Item Can be Shipped
Engine: LS2/LS3/LS7/L92/LS9, LS1/LS6
LS Engine?: Fits LS Engine
The heads have just been freshened up and have new guides, retainers, seats, and seals. They have had a fresh surface mill. They are assembled with Pac 1521 Springs and retainers. They have 2.08/1.6 valves installed and have hand pollished 58cc chambers.
The heads have 1,843 miles on them since they were R&R'd in dec. of 2010, I sent them to the machine shop to make sure they were still perfect and ready to bolt on.
All checked out, so they are ready to sell.
Im looking to get $1,950.00 for the assembled heads.
*REDUCED PRICE TO $1,750.00
Last edited by gtorep; 07-13-2011 at 03:27 PM.
Trending Topics
06-27-2011, 11:26 PM
#11
On The Tree
Thread Starter
iTrader: (18)
Join Date: Jun 2006
Location: League City, TX
Posts: 135
Likes: 0
Received 0 Likes
on
0 Posts
These still have a very thick deck, I sprayed a 200 shot without any problems. They would be fine. Ill have the pics wed.
Last edited by gtorep; 06-27-2011 at 11:34 PM.
06-27-2011, 11:38 PM
#12
TECH Enthusiast
iTrader: (17)
Join Date: Mar 2007
Location: Alexandria, VA
Posts: 575
Likes: 0
Received 0 Likes
on
0 Posts
aritey PM me when you have the pic's. Im in the process of possibly doing a HUGE 2 stage nitrous setup and if nitrous likes the low chambers like that I might jump on this. Might as well get motor setup all at once.
06-30-2011, 12:10 AM
#15
On The Tree
iTrader: (8)
Join Date: Oct 2010
Location: Houston,Tx
Posts: 113
Likes: 0
Received 0 Likes
on
0 Posts
I'm very interested but I don't know if they will work with my can and stock bottom end cam may be to big for that cc I will check tomorrow and get with you to see if I can run these
07-13-2011, 03:19 PM
#16
On The Tree
Thread Starter
iTrader: (18)
Join Date: Jun 2006
Location: League City, TX
Posts: 135
Likes: 0
Received 0 Likes
on
0 Posts
Everybody else these are still for sale @ A REDUCED PRICE!!!.....
Last edited by gtorep; 07-13-2011 at 03:25 PM.
