L92 heads 30k, LS2 TB, (2) TBSS 87mm TB's, rockers, head gaskets gaskets! etc!
09-12-2011, 03:35 PM
#1
TECH Resident
Thread Starter
iTrader: (47)
Join Date: Apr 2007
Location: Aurora, CO
Posts: 867
Likes: 0
Received 0 Likes
on
0 Posts
L92 heads 30k, LS2 TB, (2) TBSS 87mm TB's, rockers, head gaskets gaskets! etc! Category: Accessories
Price: $1
Part Fits: 2010+ Camaro, 93-02 Chevrolet Camaro, 93-02 Pontiac Firebird, Corvette, 04-06 Pontiac GTO, 04+ Cadillac CTS-V
Location (State): CO
Item Condition: Used
Shipping Information: Item Can be Shipped
Engine: LS2/LS3/LS7/L92/LS9, LS1/LS6
LS Engine?: Fits LS Engine
-GM new 5.3/5.7 multi-layer head gaskets, SOLD!
-Cal tracs, non-flip design, needs new heim joints and some touch up paint, SOLD!!!
-full set of 19k 243 rockers and stands with bolts, 70.00 shipped
-L92 heads with 30k, ready to go on!, with rockers and valve covers!!! SOLD!
-Silver blade LS2 Throttle body, known working condition, in great shape! asking 175.00 shipped obo
-(2 left!!) 90mm TBSS dbw throttle body , 50.00 shipped
-(1) c6 zo6 rear axle, has 1500 miles on it, very tiny nick in outer grease boot, silicone would fix it for sure, great spare! asking 80.00 shipped! obo
-05-07 dbw gm truck pcm, no history on this, asking 60.00 shipped? obo
-set of 6.0 exhaust manifolds and flanges for diy turbo? 70.00 shipped!
-(2 sets) gm l92 truck intake gaskets, brand new! asking 35.00 shipped!
-like new gm ls oil pump, came from a 07 silverado with 20 miles on it! brand new, asking SOLD!
-(1) known good 78mm dbw throttle body, SOLD!
-custom built water to air intercooler setup, mounts directly where factory air box went, great for rear mount turbo or blower, pm for details on this please asking 250.00 shipped obo! kept my intake temps below 90 degrees on a full 11 second 1/4 mile pass when iced down!
-04.5-07 classic, returnless style fuel pump unit with a 255 walbro already installed, good for 11's on pump gas with my turbo setup, held a solid 60 psi down whole track!! pump is 3 months old!! drop in ready! asking 150.00 shipped!
:will pull when sold!!:
-NNBS water pump, brand new, 0 miles, factory GM pump, works great for ls2 or ls3 intake swaps like i have, will barely clear water neck! SOLD!!
-brand new gm alternator/ps bracket for nbs or nnbs trucks and suvs, 0 miles, asking 75.00 shipped!
-known working 05-07 classic TAC module, SOLD!!
-05 and up alternator with 3500 miles on it, like new!, 2 wire bosch design, known good, asking 100.00 shipped!
-factory aux trans cooler off of my personal truck (07 classic) will include some of the lines with it, going bigger, has 41k on it, should fit 99 and up, i will flush it with gm machine before i send it, always had fresh fluid in it! asking 75.00 shipped!
-Gm truck/suv crank pulley/balancer assy, in good shape, asking 45.00 shipped!
Window switches out of a 04 crew cab, pm me offers?
overhead console and dome light out of 04 crew cab, pm me offers?
Switch cluster from 04 crew cab, pm me offers, will split up, NOTE! ALSO HAVE THE FOG LAMPS, if someone wants them with the fog lamp switch?
Last edited by 89LS1FOXER; 10-27-2011 at 04:48 PM.
Trending Topics
10-10-2011, 07:23 AM
#9
TECH Addict
iTrader: (3)
Join Date: Dec 2006
Location: Alvin, Texas
Posts: 2,825
Likes: 0
Received 0 Likes
on
0 Posts
Question on the TB. I just had a 5.3 to LS2/L92 swap. I'm currently using 5.3 intake, rails, harness, and TB. I have a TBSS intake available to me, with the purchase of one of your 90's, would I still have to swap the rails and harness? And would I the need of one of the X-links that you mentioned in one of the above post?
Application is for a 2002 Silverado. Thanks. Lisa
Application is for a 2002 Silverado. Thanks. Lisa
10-10-2011, 09:39 AM
#10
TECH Resident
Thread Starter
iTrader: (47)
Join Date: Apr 2007
Location: Aurora, CO
Posts: 867
Likes: 0
Received 0 Likes
on
0 Posts
you would need a cable driven 90mm 4 bolt tb to run the tbss intake unless you switched over to a newer 03 and up harness than you would need an x-link. So your running a l92 bottom end with ls2 heads??
10-10-2011, 12:23 PM
#12
Question on the TB. I just had a 5.3 to LS2/L92 swap. I'm currently using 5.3 intake, rails, harness, and TB. I have a TBSS intake available to me, with the purchase of one of your 90's, would I still have to swap the rails and harness? And would I the need of one of the X-links that you mentioned in one of the above post?
Application is for a 2002 Silverado. Thanks. Lisa
Application is for a 2002 Silverado. Thanks. Lisa
yes, the x-link is needed with a 4 bolt style TB for your truck.
Yes you can reuse everything else.
10-10-2011, 12:55 PM
#13
TECH Resident
Thread Starter
iTrader: (47)
Join Date: Apr 2007
Location: Aurora, CO
Posts: 867
Likes: 0
Received 0 Likes
on
0 Posts
correct me if im wrong but if your truck is an 02 it is not throttle by wire, its got a throttle cable, your best bang for the buck would be one of these:
http://cgi.ebay.com/ebaymotors/LS1-L...item2567ffc00c
http://cgi.ebay.com/ebaymotors/LS1-L...item2567ffc00c
10-10-2011, 01:13 PM
#14
TECH Addict
iTrader: (3)
Join Date: Dec 2006
Location: Alvin, Texas
Posts: 2,825
Likes: 0
Received 0 Likes
on
0 Posts
Matt...
Thanks.. that's a relief that I could use my orig wiring harness.
My goal is to collect all of this stuff by the beginning of the year, funds allowing, as well as the FLT upgrade, and then go for my second tune.
I'm at work, so I'm not able to follow the E-bay link. Just have to wait till I get home tonight.
Thanks.. that's a relief that I could use my orig wiring harness.
My goal is to collect all of this stuff by the beginning of the year, funds allowing, as well as the FLT upgrade, and then go for my second tune.
I'm at work, so I'm not able to follow the E-bay link. Just have to wait till I get home tonight.
10-10-2011, 09:51 PM
#18
It was only shipped yesterday? You told me that I would have them weeks ago, you responded to one of maybe 6 pm's that I have sent you so don't dare say that they were shipped when you said they would be. I paid you 3 weeks ago for them and they should have been shipped in an appropriate time frame. I would highly advise any one who is. considering dealing with you to find parts somewhere else as this has been a terrible transaction and my feedback will be reflecting that.
10-11-2011, 07:22 AM
#19
TECH Resident
Thread Starter
iTrader: (47)
Join Date: Apr 2007
Location: Aurora, CO
Posts: 867
Likes: 0
Received 0 Likes
on
0 Posts
It was only shipped yesterday? You told me that I would have them weeks ago, you responded to one of maybe 6 pm's that I have sent you so don't dare say that they were shipped when you said they would be. I paid you 3 weeks ago for them and they should have been shipped in an appropriate time frame. I would highly advise any one who is. considering dealing with you to find parts somewhere else as this has been a terrible transaction and my feedback will be reflecting that.
10-12-2011, 02:48 PM
#20
You don't have time? For what?
it was our time wasted while waiting for you to send parts that we paid for weeks ago, which we needed. We didn't pay for them for ***** and grins, we needed them. You ignored PM's while logging on to bump this thread. That's on you, period.
Don't be a jagoff, just admit the problem and apologize. It is what it is.
it was our time wasted while waiting for you to send parts that we paid for weeks ago, which we needed. We didn't pay for them for ***** and grins, we needed them. You ignored PM's while logging on to bump this thread. That's on you, period.
Don't be a jagoff, just admit the problem and apologize. It is what it is.