Rebuilt LS1
#1
Rebuilt LS1
Category: Engine - Complete Motors
Price: $2200
Part Fits: 93-02 Chevrolet Camaro, 93-02 Pontiac Firebird, Corvette, 04-06 Pontiac GTO
Location (State): FL
Item Condition: Used
Shipping Information: Item Can be Shipped
Engine: LS2/LS3/LS7/L92/LS9, LS1/LS6
LS Engine?: Fits LS Engine
Nothing wrong with it. There is no cam, lifters, or oil pump. Included are Rear and front cover ( that was ground for clearance ) for the Melling 10296 Hi volume pump. Maybe 2K miles on it as you can clearly still see the hone marks.
Crank was polished and .001 Mains and std rods. Had 60 PSI oil press with the melling 10296 !
Heads had a 3 angle valve job with new guides prior to install. I'll snap a couple new pics 2maro and upload. Over 1500 in heads alone !
$ 2200 and it's yours
9044052304 and leave message. No trades.
#3
No videos of it running. Stock rods, which I've read on here are good to 600+ hp. More then a N/A ls1 can make. Can ship at ur $ . No intake.
Have a friend who could vouch for the way it ran as he rode in the truck up to a car show with me. Also another who drives a GTO.
In future, will put a cam in and heads back on with .045 gaskets and run in stand alone mode. If it does not sell soon. Tho all acc. will not go with engine, i e ls1 intake, truck oil pan, ecm, rail, 1 3/4 Dynamaxx headers, etc.
Have a rebuilt stock ls1, ls2 / 6 liter cam, new cam bearings, rollermaster double chain, std polished crank, coated skirt pistons, gasket matched slightly milled 241 heads, stock springs, new ls7 lifters for $ 1000.
Have a friend who could vouch for the way it ran as he rode in the truck up to a car show with me. Also another who drives a GTO.
In future, will put a cam in and heads back on with .045 gaskets and run in stand alone mode. If it does not sell soon. Tho all acc. will not go with engine, i e ls1 intake, truck oil pan, ecm, rail, 1 3/4 Dynamaxx headers, etc.
Have a rebuilt stock ls1, ls2 / 6 liter cam, new cam bearings, rollermaster double chain, std polished crank, coated skirt pistons, gasket matched slightly milled 241 heads, stock springs, new ls7 lifters for $ 1000.
#5
Cam, Lifters, Chain, pushrods, Oil Pump. As my add states I have the front cover that has clearance for a Melling 10296 pump, and also a rear cover. Valley cover is still on top.
All sensors and an intake, valve covers, front acc.
All sensors and an intake, valve covers, front acc.
Trending Topics
#10
Long block tho heads are off cause I used the cam n lifters in the 402 I put in my truck.
Has ARP head studs. NO gaskets. I used Cometic .045
Buy ur cam and lifters and I'll put it together .
Has ARP head studs. NO gaskets. I used Cometic .045
Buy ur cam and lifters and I'll put it together .