02BlackWS6

Why doesn't LS1 Edit lock my converter up? The table shows it's supposed to lock it up at normal driving around 42 mph. But my Vig. never locks up. Does anyone know how to get EDIT to lock my Vig. 3600 up??? I guess what i'm getting at is the when i use a stock A4 program and use EDIT my converter never locks up. With my custom non-LS1 EDIT tuning my converter locks up fine. But i'm trying to get the most out of my LS1 Edit.

Den

<small>[ May 27, 2002, 01:52 AM: Message edited by: 02BlackWS6 ]</small>

msce2b-dustin

Have you trid lowering the lockup point. My tp4400 didn't want to lock up until I lowered the mph quiet a bit.

ChrisB

Have you deleted the p0300 code/changed the misfire enable temp to a high value?

If not try that and see if your TCC will engage.

Chris

02BlackWS6

I haven't tried lowering the lockup value, but i'll give it a try. I did delete the p0300 code.
But thanks for your ideas.

Den

Ryan K

iTrader: (11)

Change the Enable temps for the misfire detection. Have the computer enable at 142 and disable at 141 or vice versa. It is not the same as deleting the code.

Ryan K.

ChrisB

Yep, make sure you have increased the enable temp (as mentioned above) also.

Chris

02BlackWS6

The highest valve EDIT allows me to change it to is 150. If i try to change it higher it says out of range. Under what section can i find the Misfire enable??? Is it under the "Diagnostic" section?? Is has a Max. temp and a Min. temp setting. So i need to raise the Min. temp to 142?? The Max. temp is default to 142 already, and it only allows me to change it to 150 max.

Den

<small>[ May 28, 2002, 11:58 AM: Message edited by: 02BlackWS6 ]</small>

02BlackWS6

TTT

ChrisB

just set the min temp to 150.

Chris