Bad324

bought an SLP lid. Just need to clean it up and find plugs for it to install in my '99

Boxxx

That's ok I'm back to liking it again, so all is well.

Decadence75

iTrader: (17)

bleepster

iTrader: (2)

took apart drivers door to replace window regulator and motor. Need to repair 1 elongated hole where the regulator mounts.

this repair was done before by previous owner. will do repair tonight and finish up the swap this week.

Bad324

plates came over the weekend

JohnR

iTrader: (1)

I like it!

Joeyofblades

iTrader: (2)

Lt1slowerbird

Changed the oil last night. Drove home from.shop fine. Started today with a bird chirp that sounded like a dreaded spun bearing. As you can imagine I was about sick as my monster stage 2 is coming in today. Ran to store and put some MMO in it praying it was a stuck lifter wheel haha. Squeel remained. Got angry. Clutched dumped it. Cloud of smoke and no more chirping. Went to the house as I realized in my laziness of not wanting to clean a funnel I spilt some oil down the fill tube. Must have had oil on the belt somewhere. Hosed car down with some belt dressing and still no squeeking. Oil gauge is a bit twitchy when hot with 5w30 synthetic and k and n filter. Idles around 35 psi. Before I thought it idles more around 40 and not twitchy. But had Mobil 1 filter. Which I attribute the slight oil psi drop to. So that's what I did with my 2000 ws6 and about had a heart​attack. Cammed ws6 lives on(hopefully)

CoreyD

iTrader: (9)

Gonna be looking into getting one of these soon.

Had to seal my "new" tail lights today, just ran a bead of silicon around them after they started letting condensation in

jasonstiller

iTrader: (1)

Strikingly similar to mine! I like it!

sebvegas

I know that car jasonstiller

Decadence75

iTrader: (17)

Got my heads back from TEA, they purdy...

CoreyD

iTrader: (9)

Jelly.

Decadence75

iTrader: (17)

Can't wait to starting getting everything installed. I think she will scoot better with the new hardware but it will a couple weeks or so before I can begin the tear down and install.

99WS6MAN

iTrader: (2)

Replaced my battery...

blackbyrd

iTrader: (14)

man Im tempted to get one of those smoked 3rd brake lights

CoreyD

iTrader: (9)

Which heads from TEA did you end up going with? She'll scoot for sure

WS6 #3392

Ordered a set of Trick Flow As Cast 220 heads from BTR.

Decadence75

iTrader: (17)

It was a set of 243 that I sent in for the stage 2 port job with the larger valves, they also installed a set of BTR .660 dual platinum springs I sent along with the heads. Going in with these heads is a 230/234 .630/.612 112+2 cam specced by Martin and some Johnson 2110R lifters. They are replacing stock 853 heads and the GMPP HOTcam.

blackbyrd

iTrader: (14)

Ordered my led 3rd brake light