Am I calculating compression wrong?
#1
TECH Enthusiast
Thread Starter
Am I calculating compression wrong?
Trying to figure out what my compression would be for my lq4 setup and no matter what calculator I'm using it comes out weird? Or am I just reading it wrong ?
#3
ModSquad
iTrader: (6)
#5
TECH Enthusiast
Thread Starter
#6
TECH Junkie
That I do not know. I know Ls1's are .005" - .009" and I measured .007" on my motor.
Until someone with more knowledge posts up I would have to imagine the Lq4 is in the same window of deck clearance.
The number you put in I'm assuming it's deck height and they are looking for clearance. (Piston out of the hole)
I think you would be fine putting .005" - .007" in for a rough idea.
Until someone with more knowledge posts up I would have to imagine the Lq4 is in the same window of deck clearance.
The number you put in I'm assuming it's deck height and they are looking for clearance. (Piston out of the hole)
I think you would be fine putting .005" - .007" in for a rough idea.
Trending Topics
#9
TECH Senior Member