Starter problem?
If it is the small flex plate from the old motor then the old starter should work, if you used the vortec truck flex plate then you must use the truck starter and lose clearance by the header(SUKKKS).
Thread Starter
TECH Enthusiast
Joined: Dec 2005
Posts: 576
Likes: 0
ok I dont know if you guys understood me or not but I will try to explain more I got a 383 stroker engine and the block is from 98 vortec engine as the previous owner claim since the crank is 400 now which starter should I use? its now 168 tooth right?
Trending Topics
The 86+ blocks are 1 piece rear seals, the 400s were 2 piece, so unless he used an adapter he is full of it. You will need to find out how it was balanced too. The aftermarket cranks i buy must be balanced and i match them to rear balanced flywheels for LT1s ect.
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine
Verdad Gallardo
7 Most Reliable High-Performance Engines GM Has Ever Built
Verdad Gallardo
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
