92cobranotch

iTrader: (9)

never mind found it

92cobranotch

iTrader: (9)

i bet its a full bolt on car vs a stock car at that point. hooooooray who gives a **** run a full bolt on termi against a full bolt on mach. see ya different second bracket at that point

automach1

Stock car? So a intake, tune, x-pipe, cat-back cobra is a stock car Yea i have seen penty of close to full bolt on corbras run bottom 12s at our track def not a sec diffrence there

92cobranotch

iTrader: (9)

thats poor showing for a cobra. keep thinking they are all like that. i didnt watch vid or read mod list. mod for mod cobra kills mach 1. keep it comparable cars. other wise you would be bragging about beating a full bolt on 89 civic

Stopsign32v

iTrader: (1)

I'll run a 03 Cobra with nothing but gears, intake, x pipe, and catback like myself. Infact I've tried to find one on SVTP locally but couldn't.

92cobranotch

iTrader: (9)

id love to see it but pulley is always before those mods. if the termi was on same tire as you with same gear and hooked up you would be in trouble. how ever its gonna be impossible to find one comparable. and if you won you bost likely beat the driver not the car

Stopsign32v

iTrader: (1)

If I came within 2 carlengths of the same car PLUS A SUPERCHARGER, then that would be ******* sad. I should get raped by a 03/04 Cobra with the same mods but I wouldn't. One of the reasons I like the Mach 1 so much....

92cobranotch

iTrader: (9)

if the cobra hooked with 456s game over for mach 1 more than two cars

automach1

No not really they are decent drivers yellow cobra in vid went 12.0 @ 117-120. I have also seen 11.8 @ 121, 11.9 @ 117 and 12.1 @ 121 all diffrent pullied cobras.

92cobranotch

iTrader: (9)

there are quite a few cobras that go 11.50s and faster with these mods. i think unit went 11.20 but thats extremely rare

Stopsign32v

iTrader: (1)

Wonder how many times it could do that.

92cobranotch

iTrader: (9)

i would consider a full bolt on cobra long tubes single blade. upper and lower pulley. intake gear etc etc. not just 1 mod here or there im talkin full bolt ons

automach1

Quite a few bolt-on 4v cars in the 11s too

92cobranotch

iTrader: (9)

i bet not more than 5back to back. but 1 time is all it takes

92cobranotch

iTrader: (9)

stoppy if i could find a mach motor with those real good rods you was talkin about earlier for around 1000 id put it in notch with eaton for summer while i rebuilt my motor

Stopsign32v

iTrader: (1)

So you think

Stopsign32v

iTrader: (1)

Drop in a 5.4 Navi motor NA with some pression and sum camz. Should give ol Heyhoe a good run for his money.

92cobranotch

iTrader: (9)

those dont have those junky powdered rods like termis do they? rofflmao

Stopsign32v

iTrader: (1)

They have plastic rods

92cobranotch

iTrader: (9)

for comparison what does a 12.0 bolt on mach usualy trap?