WS6 vs Redfire Cobra
#1
WS6 vs Redfire Cobra
I witnessed a friendly race between a silver WS6 and a 04'redfire Cobra the WS6 had the Cobra by a car or so! the Cobra had bassani long tubes,Xpipe and catback with upgraded pulley,410 gears,and a heat exchanger(don't know what brand) and he claimed to have made 488rwhp on a conservative tune? The WS6 was on motor only and was "LS1 stock" so he claims!
#5
Administrator
Originally Posted by Omega Doom
he claimed to have made 488rwhp on a conservative tune?
That's just not going to happen, even with 25* of timing, race gas,
etc. I don't care what a dyno says. Numbers can be skewed easily.
I've been there, done that.
It's very easy for a non-ported Eaton Cobra to put down 460rwhp
one run and 425rwhp or so the next due to horrible inefficiencies
with that blower. I've run 11.30's then 12.20's the next pass.
I consider that a "partially modded" Cobra. I believe almost any
loss given those mods.
#7
Administrator
Originally Posted by BayAreaSS
A stock ls1 can't beat a pullied cobra. Unless the cobra missed a gear.
Originally Posted by Omega Doom
The WS6 was on motor only and was "LS1 stock"
Trending Topics
#9
I witnessed Aliens taking all the Honda's in the world then dropping the back off here with a fart tip lower euro lights, and LED windshield washer lights.
Hey, it could happen right?
Hey, it could happen right?
#14
9 Sec. Club!!!
iTrader: (1)
Join Date: Jul 2004
Location: HEB TX
Posts: 1,492
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by Omega Doom
ok,ok he fessed up but I wanted to see how many would call BS! he was a H/C full exhaust and 4000 stalled car! not sure what he dynoed but the Cobra did have a ported blower!