New suspension adj. now road noise
Trending Topics
#8
TECH Fanatic
Yes, please specify ! I have rod end on every suspension pice, from upper/ lower A arms to panhard rod. Rock hard set up with Koni and BMR springs + sfc and strano swaybars f+r.......it is noisy but when it comes to handle turns, all it´s forgiven..
#12
TECH Fanatic
Join Date: Jan 2011
Location: Michigan
Posts: 1,358
Likes: 0
Received 0 Likes
on
0 Posts
Only problem I had with my little suspension was a alittle driveline vibration from the adj. torque arm. Adjusted it and it's a nice setup now...but no noise though.
#13
TECH Senior Member
iTrader: (35)
Most, if not all the noise is coming from the LCAs, the PHB transfers very little to no noise. I'd get a set of UMI poly bushing control arm ends to replace the rod ends mounting to the body.
http://www.umiperformance.com/catalo...roducts_id=262
http://www.umiperformance.com/catalo...roducts_id=262
#14
LS1Tech Premium Sponsor
iTrader: (5)
This is why I try to steer people away from rod ends unless they truly know what they're getting into. Also, adjustable lowers aren't necessary unless you're looking to go with an aftermarket rearend (sometimes holes are a little off) or a taller tire to center the wheel well.
What parts do you have installed?
- Kevin
PS: I agree. The lower control arms will transfer the most noise next to the torque arm. All road noises and gear whine will find their way into your ears. haha
What parts do you have installed?
- Kevin
PS: I agree. The lower control arms will transfer the most noise next to the torque arm. All road noises and gear whine will find their way into your ears. haha
#15
i just finished the install of sphoon adjustable tq arm with the rod end up front and i must say im going to have to get used to the noice was not aware of how much noice it makes from power transfer, no load , load i guess im going to have to check all the bolts make sure everything is still snug