Having a possible bent subfame
Thread Starter
Staging Lane
Joined: Dec 2019
Posts: 75
Likes: 0
From: Arizona
Having a possible bent subfame The car is a 2001 camaro z28. currently k frame is out of car and ordered a new one and won’t fit. The front of the frame is too wide to fit the new k frame. the old k-frame fits and lines up fine. I’m wondering if the in frame and subframe are bent? Maybe that’s why it fits and the new in frame won’t fit. Also i’ve tried a umi and midwest chassis knfeames and both seem to narrow to fit into car. Is there a way to maybe bend it in to fit the new k frame? at this point just going to put the original one back in. Any help is appreciated.Thanks!
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo
Awesome K5 Blazer Restomod Comes With C7 Corvette Power
Verdad Gallardo
10 Camaros You Should Never Buy
10 LS Engine Myths That Refuse to Die
Verdad Gallardo
Launching!
Joined: Oct 2014
Posts: 220
Likes: 36
I did the under the car engine swap and dropped it with the k member. When I raised it back up the bolt holes were off. I raised it enough to get all the bolts to all start threading in and it straightened out as I tightened them.