dubs6

iTrader: (1)

Ok so after i was on the dyno 2 weeks ago my ABS light came on and hasnt gone off. i have a 2001 T/A w/o TCS.

here is what i have tried:
1. a search
2. checked wires on and near the rearend.
3. unhooked battery and plugged it back
4. unhooked wires near rear and plugged them back
5. visual inspection

ok so i dont know what else to do. it stays on all the time. i didnt change the tires but i did heads and cam two weeks before. i am guessing that there must be something wrong electronincally. on my lt1 the msd wires set it off so i just had to reroute them but i cant do that with these wires. also the wires were on for two weeks before this started. ok. go.

dubs6

iTrader: (1)

lil help.... i checked the fuses too.

BAD2000TA

iTrader: (6)

Whenever I would get my car dyno'd, the ABS inop light would come on too. But, mine has always gone out relatively quickly. Check with other sposor that does Dyno's. I've always gone to MTI - call them and see if this has happened with other customer's cars.

Xsta Z 28

iTrader: (2)

Last time I had my car on the dyno, there was a harness unplugged under the car, it is mounted to the underside of the floor board over the rear axle, on the drivers side . . .

WAHUSKER

iTrader: (4)

That's what mine was too.....

dubs6

iTrader: (1)

thank you... read #2.

2000Z28M6

iTrader: (13)

i would of tried a better search.........but mine went out and it was a wheel speed sensor. So ur goin to have to bite the bullet and have them tested at a shop or dealership. KInda PITA but it happens.

dubs6

iTrader: (1)

that is what i figured. sorry much search wasnt up to your par.