HP tuner histogram help
HP tuner histogram help Anyone out there wanna help me with what I am doing wrong trying to set up my MAF histogram.I can drive to meet someone and pay. Thanks for any help. You can pm me or reply here. I am in the lakejackson area, but can drive to houston or anywhere reasonable.
Are you just trying to tune the MAF table?
I adjusted the VE tables and my book says the mass air vs output frequency is next but when I go by the directions and reset the maf fail high back to the original setting and so on it all seems to work fine until I hit the start scan triangle on the histo I configured. It tells me this parameter is not supported.
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo
Awesome K5 Blazer Restomod Comes With C7 Corvette Power
Verdad Gallardo
10 Camaros You Should Never Buy
10 LS Engine Myths That Refuse to Die
Verdad Gallardo
Thanks Thanks for the quik responses, you guys are awesome. It turns out that even though I had MAF identified in the primary tables, it was the wrong MAF. I actually needed MAF (Hz). It seems to work fine now. I just have to wait until tomorrow when the sun comes back up to actually try it with my tune file in my car. 
