WTT: Mid 9 second 78 Malibu 10.0 index car!
#1
WTT: Mid 9 second 78 Malibu 10.0 index car!
9.57 @ 144 MPH on 150shot
10.80 @ 128 MPH on Motor (Nitrous tune)
Car was run in two 10.0 index classed this year, making the final round in one of them.
Engine:
406 J&E Performance Engine
14:1 Compression
Pontiac Brodix Heads
Victor Jr fully ported intake
Cam - Unknown
EWP
Hooker Headers with 4 inch collectors and 4 inch flowmasters
Tranny:
Fully built Turbo 400
Bandit shifter
4000 rpm nitrous converter (Maker unknown)
Rear:
Looks like a 12 bolt or 9 inch (have to look closer)
Axles unknown
Spool
4.11
Drag sway bar
Adj upper control arms
both springs airbagged
Lakewood shocks
Chassis:
Full Black interior
10 point cage
Line Lock
Window net
325 Drag radials mounted on Rims in Pics
Fuel:
Fuel Pump unkown (Loud)
Seperate fuel system for nitrous with Holley blue pump and 1 gallon cell.
10 or 15 Gallon Fuel Cell (not sure)
NX Plate Kit w 10lb bottle
Electronics:
MSD 6al
MSD Distributor
Taylor Wires
MSD window switch.
Any questions Email me - shotat1@dejazzd.com
Car is located in Douglassville PA near Reading/Philly.
I am looking for a clean LS1. I am partial to WS6 TA's, but I am open to all. This car was just acquired for a killer price, it is ready to race right now. Sorry for some of the unknowns. I will clean them up as I take a better look at the car. I have already taken the car out on the street and it is rediculous.
10.80 @ 128 MPH on Motor (Nitrous tune)
Car was run in two 10.0 index classed this year, making the final round in one of them.
Engine:
406 J&E Performance Engine
14:1 Compression
Pontiac Brodix Heads
Victor Jr fully ported intake
Cam - Unknown
EWP
Hooker Headers with 4 inch collectors and 4 inch flowmasters
Tranny:
Fully built Turbo 400
Bandit shifter
4000 rpm nitrous converter (Maker unknown)
Rear:
Looks like a 12 bolt or 9 inch (have to look closer)
Axles unknown
Spool
4.11
Drag sway bar
Adj upper control arms
both springs airbagged
Lakewood shocks
Chassis:
Full Black interior
10 point cage
Line Lock
Window net
325 Drag radials mounted on Rims in Pics
Fuel:
Fuel Pump unkown (Loud)
Seperate fuel system for nitrous with Holley blue pump and 1 gallon cell.
10 or 15 Gallon Fuel Cell (not sure)
NX Plate Kit w 10lb bottle
Electronics:
MSD 6al
MSD Distributor
Taylor Wires
MSD window switch.
Any questions Email me - shotat1@dejazzd.com
Car is located in Douglassville PA near Reading/Philly.
I am looking for a clean LS1. I am partial to WS6 TA's, but I am open to all. This car was just acquired for a killer price, it is ready to race right now. Sorry for some of the unknowns. I will clean them up as I take a better look at the car. I have already taken the car out on the street and it is rediculous.
Last edited by 347fairless; 12-12-2007 at 05:30 AM.
#3