welding axle tubes
#1
TECH Regular
Thread Starter
iTrader: (19)
Join Date: Apr 2007
Location: longbeach CA
Posts: 487
Likes: 0
Received 0 Likes
on
0 Posts
![](https://ls1tech.com/forums/images/ranks/ls1tech10year.png)
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
does any one have a pic of this mod i was told it helps reinforce the stock 10 bolt input needed please i am bored and have a welder and get all my rods for free at welding class i wont waste no money in this project
#18
TECH Addict
iTrader: (14)
Join Date: May 2005
Location: Simi Valley, CA.
Posts: 2,727
Likes: 0
Received 0 Likes
on
0 Posts
![](https://ls1tech.com/forums/images/ranks/ls1tech10year.png)
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
Just toss it on a jig and weld that bitch up, make sure it's empty and degreased though, i have heard that the oil can seep through and make a weak weld. I do think a back brace would be of more benefit though. Something like this:
![](http://www.demoderbypitstop.com/images/chevy10bolt.jpg)
the sides are welded and the center is a bolt-on piece, but then at that point it's just a waste of money, and should be tossed out in favor of a 12bolt.
![](http://www.demoderbypitstop.com/images/chevy10bolt.jpg)
the sides are welded and the center is a bolt-on piece, but then at that point it's just a waste of money, and should be tossed out in favor of a 12bolt.