4 Sale - Baer Eradaspeed Rotors +(front), Hawk HPS pads
10-29-2013, 09:15 AM
#1
TECH Resident
Thread Starter
4 Sale - Baer Eradaspeed Rotors +(front), Hawk HPS pads Have a set of used rotors taken off Sara (01 Z28) and the matched pads. Rotors have a little over 50% left, pads are at 70%.
PART#BAE2301006
GM FRONT ROTORS
F-Body Camaro Firebird 1998 2002 Front 2301006 12.00 diameter
The EradiSpeed+ Features: EradiSpeed+ are stock size direct replacement rotors that are a 2 piece design
Designed to be used with factory calipers
EradiSpeed rotors feature premium high silicon content iron castings.
Rotor plates or outer rotor surfaces are cast with additional mass to absorb additional heat.
Internal curved and directional vanes maximize air flow and cooling.
Externally slotting and drilling alleviate friction losses from pad outgassing and a zinc chromate surface finish resists rust.
Counter rotational application of slots and holes further resists pad transfer and balance issues associated with patterns which run in the conventional direction of rotation.
Each gas relief hole drilled in an EradiSpeed rotor is located directly behind an internal vane and chamfered appropriately.
6061 T-6 billet aluminum hat (anodized black) and bolted to the rotor
High grade U281 fine thread stainless hardware (with captured nuts).
I am located in San Diego
$100 firm. Will ship inside continental U.S. @ additional cost.
Interested parties e mail : gurrzt@hotmail.com
PART#BAE2301006
GM FRONT ROTORS
F-Body Camaro Firebird 1998 2002 Front 2301006 12.00 diameter
The EradiSpeed+ Features: EradiSpeed+ are stock size direct replacement rotors that are a 2 piece design
Designed to be used with factory calipers
EradiSpeed rotors feature premium high silicon content iron castings.
Rotor plates or outer rotor surfaces are cast with additional mass to absorb additional heat.
Internal curved and directional vanes maximize air flow and cooling.
Externally slotting and drilling alleviate friction losses from pad outgassing and a zinc chromate surface finish resists rust.
Counter rotational application of slots and holes further resists pad transfer and balance issues associated with patterns which run in the conventional direction of rotation.
Each gas relief hole drilled in an EradiSpeed rotor is located directly behind an internal vane and chamfered appropriately.
6061 T-6 billet aluminum hat (anodized black) and bolted to the rotor
High grade U281 fine thread stainless hardware (with captured nuts).
I am located in San Diego
$100 firm. Will ship inside continental U.S. @ additional cost.
Interested parties e mail : gurrzt@hotmail.com
Last edited by SteveC; 11-04-2013 at 07:08 AM.
11-03-2013, 11:06 AM
#5
TECH Resident
Thread Starter
