10.28 @ 134 1.53 60'.... Who says you can't get down on a 10 bolt...
#1
10.28 @ 134 1.53 60'.... Who says you can't get down on a 10 bolt...
Already posted in results, but I thought you guys would get a kick out of this...
Finally made a few good hits on the new nitrous kit last night (175ish hit on a ZEX perimeter plate). Previously the car had been 11.41 @ 122 on the motor. The best pass was:
60' 1.53
1/8 6.61
mph 107.48
1/4 10.28
mph 134.17
There is a brief mod overview in my sig. All of this on a stock cubic inch motor, factory stock 10 bolt, and factory torque arm.... Drove it to the track, ran a couple low 10sec passes (one of which netted a 136.5mph but a higher et), and drove it home. Needless to say, I'm really happy with the car!!!
Finally made a few good hits on the new nitrous kit last night (175ish hit on a ZEX perimeter plate). Previously the car had been 11.41 @ 122 on the motor. The best pass was:
60' 1.53
1/8 6.61
mph 107.48
1/4 10.28
mph 134.17
There is a brief mod overview in my sig. All of this on a stock cubic inch motor, factory stock 10 bolt, and factory torque arm.... Drove it to the track, ran a couple low 10sec passes (one of which netted a 136.5mph but a higher et), and drove it home. Needless to say, I'm really happy with the car!!!
#6
TECH Fanatic
iTrader: (20)
What gear? Its mainly the 6 speed cars with 4.10 that strip the pinion teeth off, then if that doesn't break the small 27 spline axle will. But in an auto the 10 bolt can last, what size tire? 26? the taller the tire the more stress there is. I'd say with a stick car 1.70 slipping the clutch is the limit but in an auto i've seen a local guy run mid 1.5xx all season long running 10.6-11.0
Trending Topics
#8
10 Second Club
iTrader: (228)
Congrats nice to see other cars getting it done on a 10 bolt also. I did about the same high 1.3x 60ft's on a 10 bolt with 2 series carrier and 3.42's on a 26" Hoosier slick. Also with stock TA!! Only diffrence was I was trailered in cause I live bout 45 mins - 1hr away from track. BTW awesome MPH!!
#16
Launching!
iTrader: (35)
Join Date: Nov 2002
Location: Tallapoosa, GA
Posts: 239
Likes: 0
Received 0 Likes
on
0 Posts
I've run a 1.45 60ft. on the stock 10-bolt/torque arm setup.
Setup was a 99 camaro SS
-Stock 10-bolt, TA cover, welded axle tubes, auburn diff, 3.42 gear
-TH350 3000 stall
-LQ4 Cam only + 200 shot plate out the hole
-275/50/15 MT Drag Radial
Setup was a 99 camaro SS
-Stock 10-bolt, TA cover, welded axle tubes, auburn diff, 3.42 gear
-TH350 3000 stall
-LQ4 Cam only + 200 shot plate out the hole
-275/50/15 MT Drag Radial