I was finally able to pick up my 6LE Splitter today. It went on with no problems at all, and looks great.

Here are a few of the pictures:

 

It's to far out.....IMO

 

I was going to post the same thing. It needs to be recessed more.

BTW how hard is it to put on? How long does it take?

 

Agreed.

Car looks ******* sweet though.

 

I agree that it is too far out. In the pictures, it is virtually fully extended.

I will grab recessed pictures tomorrow.

It was really straightforward to put on. Not difficult at all. I'd say it should realistically take around an hour.

 

x2 on recessing it a little, other than that it looks great !

 

I thought I would like it more than I do. I'm kinda "ehh" about it all. It looks great on the Camaro, but on the Forms it's just meh. I'll still toss 6LE a BJ though.

 

Maybe I'm being a whiner but it does seem like everyone's splitter pictures are taken in either midday sun or midnight and you can never get the whole perspective

 

your going to give him a blow job for one?


you need to lower your car, looks like its just wearing a bib with how high it is from the ground

 

What exactly are the point of these splitters

 

It creates less turbulence under the car and more down force...

I also created ours to get more air to the radiator and of course protect the paint on your bumper from getting scraped up

Adam's car looks AMAZING! Like my car's hot sister

 

They can be recessed more... However, I kind of like the fact that it makes the car look more aggressive full extended (Formula's are a little more low key than Trans-Ams and I think this is a nice touch).

Fully extended + triple digits I'd probably add support bars for stiffness...





On a side note, a splitter just saw OVER 150mph in Vegas (racing a twin turbo Stealth which it beat) and no deflection or vibration AND the car handled better with the splitter than without

 

Looks ******* sweet

 

firebird, trans am splitter dumdumdum

 

Why do so many people take these splitter pictures at night when you can't see ****?

 

Because I got it yesterday, and by the time it was installed it was dark out.

I will have more pictures later this morning...there is still frost on the car.

Unfortunately, due to my exhaust setup, it's not exactly possible.

 

Im not real sure about these.. Maybe if they they followed the curves of the bumper more or the texture of it or something like this picture they may be ok. It almost looks like someone found a big piece of plastic and cut a shape out then bolted it to there bumper.

 

Here are some more pictures. The splitter was not 100% retracted. Rather it was roughly 50/50.

 

That looks great IMO

 

looks good