gauges fuxxedd after installing led bulbs?
10-04-2010, 08:29 PM
#1
TECH Regular
Thread Starter
iTrader: (4)
Join Date: Mar 2009
Location: ATX
Posts: 414
Likes: 0
Received 0 Likes
on
0 Posts
gauges fuxxedd after installing led bulbs? i just installed bulbs from superbrightled and now all of my gauges are messed up
the rpm needle just stays at 7000, the spedo starts at 120 now, instead of 0, and all of my volt,water temp, oil pressure gauges do similar things and do not read right at all, and now my low water/coolant light is on
what do i do?
the rpm needle just stays at 7000, the spedo starts at 120 now, instead of 0, and all of my volt,water temp, oil pressure gauges do similar things and do not read right at all, and now my low water/coolant light is on
what do i do?
Trending Topics
10-05-2010, 08:23 PM
#10
TECH Regular
Thread Starter
iTrader: (4)
Join Date: Mar 2009
Location: ATX
Posts: 414
Likes: 0
Received 0 Likes
on
0 Posts
well my gauges were working fine before i pulled the cluster, i dont see how my battery could have made this happen in the 10minutes it took me to swap bulbs
10-05-2010, 08:24 PM
#11
TECH Regular
Thread Starter
iTrader: (4)
Join Date: Mar 2009
Location: ATX
Posts: 414
Likes: 0
Received 0 Likes
on
0 Posts
yes i did take the clear part off because my overlay was nasty looking so i swapped it with a clean one, but i swapped all the sensors off my working one, everytime i take the sensors off and re install them i get different results and placements on the needles
