custom ls1 intake with polished radiator shroud
#1
TECH Resident
Thread Starter
Join Date: Jul 2004
Location: It's hard work to look this good
Posts: 813
Likes: 0
Received 0 Likes
on
0 Posts
custom ls1 intake with polished radiator shroud
Here are some updated pics of my custom made dual cone air intake in conjunction with my new bmr radiator shroud. Just thought I would share some pics of my engineering skills. Way cheaper to make than to buy a K&N or Volant intake!
Last edited by Tranzaman00; 06-21-2005 at 05:58 PM.
#3
TECH Resident
Thread Starter
Join Date: Jul 2004
Location: It's hard work to look this good
Posts: 813
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by Schwindj
That shroud looks awesome!
Thanks, It is from BMR one of our sponsors. It is of great quality and fitment.
Not that it really matters but both sides of this thing are mirror polished. It is also SS not aluminum.
#5
TECH Resident
Thread Starter
Join Date: Jul 2004
Location: It's hard work to look this good
Posts: 813
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by parbreak
I too have the polished BMR shroud and use it with my FIPK intake. Works perfectly.
Bryan
parbreak
Bryan
parbreak
Trending Topics
#10
TECH Resident
Thread Starter
Join Date: Jul 2004
Location: It's hard work to look this good
Posts: 813
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by DopeFedZ
Nice job with the fab work.
#12
TECH Resident
Thread Starter
Join Date: Jul 2004
Location: It's hard work to look this good
Posts: 813
Likes: 0
Received 0 Likes
on
0 Posts
I make them out of molded abs and extreme high temp rubber fitting and polised SS band clamp and SS hose clamps. I also fabbed this up. Ram air out of a stock hood which feeds directly to my intake. Whatcha think as far as power gains.
#17
TECH Resident
Thread Starter
Join Date: Jul 2004
Location: It's hard work to look this good
Posts: 813
Likes: 0
Received 0 Likes
on
0 Posts
filter came in but now I'll have to figure out how to go from the elongated oval flange coming off the filter to the 31/2 round dia of the MAF end. I didn't pay much attention to this when ordering it.
#18
TECH Resident
Thread Starter
Join Date: Jul 2004
Location: It's hard work to look this good
Posts: 813
Likes: 0
Received 0 Likes
on
0 Posts
only a few hours left till auction ends.
I had the ebay auction posted but took it off this post, because I realized I might not have been aloud to post it here.
I had the ebay auction posted but took it off this post, because I realized I might not have been aloud to post it here.
Last edited by Tranzaman00; 06-25-2005 at 07:31 AM.